CONNECTS 2 CAM-FT1-RT OEM Reverse Camera Retention Interface User Guide
- June 11, 2024
- CONNECTS 2
Table of Contents
CONNECTS 2 CAM-FT1-RT OEM Reverse Camera Retention Interface
APPLICATION
Fiat Ducato (8 Series) 2021 – UP
The CAM-FT1-RT is designed to retain the factory HD camera when replacing the
factory head unit with an aftermarket unit. This retention interface allows
for both AHD and CVBS signals to be retained through the aftermarket unit.
AHD Output: 1280×720 (25fps)
CVBS Output: 720×480 (NTSC)
DISCLAIME
Prior to Installation
Read the manual prior to installation. Technical knowledge is necessary for
installation. The place of installation must be free of moisture and away from
heat sources. Please ensure you use the correct tools to avoid damage to the
vehicle or product.
Connects2 can not be held responsible for the installation of this
product.
Technical Support
Connects2 want to provide a fast and suitable resolution should you encounter
any technical issues. With this in mind, when contacting Connects2, try to
provide as much Information as possible. This will speed up the process and
help us to help you. Please use our dedicated online technical support
centre:support.connects2.com
CONTENTS
- Camera Retention Interface
- Camera Retention Lead
- Instructions
INSTALLATION
-
Connect the orange LVDS connector from the vehicle to the top of the CAM-FT1-RT interface.
-
If utilising the AHD Output, you will need to cut the loop found on the camera retention lead. When done, connect the AHD Output RCA connector to the head unit.
-
If using a CVBS Output connector, ignore step 2 and connect the CVBS Output RCA connector to the head unit.
-
The following wires will need to be attached to the head unit:
– ACC: 12V Accessory
– B+: 12V Permanent
– GND: Ground
– ILL : Illumination (only needed if using AHD Output) -
Connect the power to the head unit and test the camera to ensure that the image is displayed correctly.
Subscribe to our YouTube Channel for installation
guides and tips…
www.youtube.com/connects2
