Trust AWST-8800 Wireless Wall Switch Transmitter User Manual

June 11, 2024
Trust

SWITCH-IN
START-LINE
TRANSMITTER AWST-8800
USER MANUAL
MULTI LANGUAGETrust AWST 8800 Wireless Wall Switch
Transmitter

AWST-8800 Wireless Wall Switch Transmitter

Item 71075 Version 1.0
Always read the instructions before using this productTrust AWST 8800
Wireless Wall Switch Transmitter - Figure 1Trust AWST 8800 Wireless Wall Switch Transmitter - Figure
2

  1. Open wall switch
    A Open the wall switch with a screwdriver.

  2. Learn code to Trust Smart Home receiver
    To control 1 or several receivers simultaneously, assign the transmitter code to 1 or more receivers. Read the receivers manual for the code learning procedure. Send an ON-signal by pressing the [ON] button while the learn mode is active.

  3. Set the switch-off delay time
    In position [0], the light stays on until you send an off-signal manually. By setting the switch to 5s/30s/2m/10m/30m/1h/3h, the transmitter will automatically send an OFF-signal after the selected time (5 seconds/… /3 hours). If you press ON in the meantime, the wall switch will restart the countdown.

  4. Affix the transmitter using screws
    A Use a flathead screwdriver to remove the button first.
    B Then place the flat screwdriver in the recess of the frame and lift the screwdriver to unclip the frame from the back plate.
    C Screw the backplate to a location with a flat surface (make sure the arrow on the back plate points up). First click the frame back onto the backplate and then the push button.

  5. Affix the transmitter using doublesided tape
    A Apply double-sided tape to the back of the wireless switch.
    B Stick the wireless wall switch onto a flat surface, e.g. a wall.

  6. Control 1 or multiple Trust Smart Home receivers
    You can assign the AWST-8800 to one receiver or you can assign the AWST-8800 to multiple receivers, to control them simultaneously. Read the receivers manual for the code learning procedure.

  7. Manual operation of a Trust Smart Home on/off receiver
    A Press ON once to switch the receiver on.
    B Press OFF to switch the receiver off.

  8. Manual operation of a Trust Smart Home dimmer receiver
    A Press ON once to switch the receiver on.
    B Press ON again to activate the dim-mode.
    The light will slowly dim up and down.
    C Press ON a third time to select the desired light intensity.
    D Press OFF to switch the receiver off.

  9. Manual operation of a Trust Smart Home electric screens receiver
    A Send an ON-signal to raise the screen.
    B Send an ON-signal again to stop.
    C Send an OFF-signal to lower the screen.
    D Send an OFF-signal again to stop.
    Read the receivers manual to reverse the direction of the screen, if needed.

  10. Replace transmitter battery
    A Use a flathead screwdriver to remove the button first.
    B Then place the flat screwdriver in the recess of the frame and lift the screwdriver to unclip the frame from the back plate.
    C Remove the battery by inserting the flat screwdriver into the slot and sliding the battery out.
    D When replacing the push button, make sure that the recess of the push button is on the same side as the recess of the frame.

Insert a new CR2032 battery. Make sure the + side is facing up. The wireless wall switch is now ready for use again.

Safety Instructions

Product support: www.trust.com/71075. Warranty conditions: www.trust.com/warranty
To ensure safe handling of the device, follow the safety advice on: www.trust.com/safety
The Wireless range is strongly dependent on local conditions such as the presence of HR glass and reinforced concrete. Never use Trust Smart Home products for life-support systems. This product is not water-resistant. Do not attempt to repair this product. Wire colors may vary per country. Contact an electrician when in doubt about wiring. Never connect lights or equipment that exceed the maximum load of the receiver. Exercise caution when installing a receiver voltage may be present, even when a receiver is switched off. Maximum radio transmit power: -10.25 dBm. Radio transmission frequency range: 433,92 MHz
Disposal of packaging materials – Dispose of packaging materials which are no longer needed in accordance with applicable local regulations. The packaging materials have been selected for their environmental friendliness and ease of disposal and are therefore recyclable.
Disposal of the device – The adjacent symbol of a crossed-out wheelie bin means that this device is subject to Directive 2012/19/EU. his directive states that this device may not be disposed of in normal household waste at the end of its usable life, but must be handed over to specially set-up collection locations, recycling depots or disposal companies. This disposal is free of charge for the user.
Disposal of batteries – Used batteries may not be disposed of in household waste. Only dispose of batteries when they are fully discharged. Dispose of batteries according to local regulations. Cover the poles of partially discharged batteries with tape to prevent short circuits.
Trust Electronics Ltd. declares that item number 71075/71075-02 is in compliance with Directive Electromagnetic Compatibility Regulations 2016, Radio Equipment Regulations 2017. The full text of the declaration of conformity is available at the following internet address: www.trust.com/compliance
Trust International B.V. declares that item number 71075/71075-02 is in compliance with Directive 2014/53/EU – 2011/65/EU. The full text of the EU declaration of conformity is available at the following web address: www.trust.com/compliance

Declaration of Conformity
Trust International B.V. declares that this Trust Smart Home-product:
Model: AWST-8800 Wireless Wall Switch
Item number: 71075/71075-02
Intended use: Indoor
is in compliance with the essential requirements and other relevant provisions of the following directives:
ROHS 2 Directive (2011/65/EU)
RED Directive (2014/53/EU)
The full text of the EU declaration of conformity is available at the following web address: www.trust.com/compliance
TRUST SMART HOME
LAAN VAN BARCELONA 600
3317DD DORDRECHT
NEDERLAND
www.trust.com
Trust Electronics Ltd.,
Sopwith Dr, Weybridge, KT13 0NT, UK.
All brand names are registered trademarks of their respective owners.
Specifications are subject to change without prior notice.
Made in China.

TECHNICAL SPECIFICATIONS

Codesystem Automatic
Number of channels 1
Turn OFF Timer 0 = no turn off timer or after 5/30 seconds, 2/10/30 minutes,

1/3 hours
Power| 1x 3 Volt CR2032 lithium (included)
Size| HxWxD: 80 x 80 x 17 mm

www.trust.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals