greenlux Chain GL25 Series Recessed LED Linear Light User Manual
- June 11, 2024
- GREENLUX
Table of Contents
greenlux Chain GL25 Series Recessed LED Linear Light
Please read the manual carefully before installation and application, and use
the product in the correct way. Instructions on accessories are included in
the manual.
Please properly maintain the manual after reading and understanding it for
convenient reference by all users of the product in the future.
Pendant: Chain GLH25 User Manual
-
Measured the distance “L” between the two pendant cables, drill two φ5mm holes in the corresponding positions on the ceiling, install the screw stopper into the hole.
-
Screw the one end of the pendant cable into the ceiling, as shown below.
-
Pull the cable to adjust the cable length, as shown below.
-
Power connection, then finish.
Pendant: Chain GLS25 User Manual
-
Measured the distance “L” between the two pendant cables, drill two φ5mm holes in the corresponding positions on the ceiling, install the screw stopper into the hole.
-
Screw the one end of the pendant cable into the ceiling, as shown below.
-
Pull the cable to adjust the cable length, as shown below.
-
Power connection, then finish.
Surface Mounted: Chain GLM25 User Manual
-
Measure the distance L between the clips, lock the rotating clip, and open the power line hole of the ceiling at the same time.
-
Align the clip position and pass the power line through the power line hole at the same time.
-
After the profile is close to the clip, rotate the clip to fix the profile.
-
After the installation is completed, the lamp can be turned on when it is powered on.
Wall Mounted: Chain GLC25 User Manual
-
Prepare the required accessories
-
Measure the distance of installation holes, open Ø5mm holes on the wall.
Drive into expansion plug and fix with screws.
-
Connect cable of luminaire to power supply, then then snap keyholes of luminaire into the screws.
-
Finish installation. Power on to light up luminaire.
Surface Mounted: Chain GLH25 User Manual
-
Insert 2pcs ceiling fitting into both ends of profile back.
-
Lock the fixing screw.
-
Measure the distance L between the clips, lock the rotating clip, and open the power line hole of the ceiling at the same time.
-
Align the clip position and pass the power line through the power line hole at the same time.
-
After the profile is close to the clip, rotate the clip to fix the profile.
-
After the installation is completed, the lamp can be turned on when it is powered on.
Greenlux 37 Chelmsford Street, Williamstown North VIC 3016 Australia
Phone: 1300 650 625
Email: enquiries@greenlux.com.au
Facebook: greenluxlighting Twitter: GreenluxLED
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>