Econoboard 6012 Uncoated Insulation Boards Installation Guide
- June 9, 2024
- Econoboard
Table of Contents
Econoboard Insulation
Uncoated Insulation Boards
Installation Guide
Econoboard Uncoated Installation
Econoboard Uncoated Insulation Boards are an extruded polystyrene board designed for use on concrete substrates
Installation steps:
- Measure your floor space and calculate how many boards you will need using the simple formula below
- Cut the Econoboard Uncoated to size to suit your room layout. Econoboard coated can be cut very easily using a sharp blade or wood saw. Please take appropriate care when using sharp tools.
- Ensure your substrate is secure, clean and free from dust and loose particles. Mix flexible tile adhesive in accordance with manufacturer instructions and spread using a notched trowel.
- Lay the Econoboard onto the adhesive taking care to squeeze out any air pockets in the adhesive. For a more secure finish make sure all boards are flush and tape over seams using Reinforcing tape (6015)
Pro Tip:
Spread enough adhesive for one board at a time to prevent adhesive drying
between board application
ENSURE THE SUBSTRATE IS SECURE, LEVEL, CLEAN AND FREE OF DUST BEFORE
INSTALLING ECONOBOARD
ENSURE ALL AIR POCKETS ARE SQUEEZED OUT WHEN LAYING THE ECONOBOARD ONTO
ADHESIVE
DO NOT LAY ON TOP OF UNDERFLOOR HEATING
TAKE CARE TO ENSURE ALL JOINS ARE FLUSH AS POSSIBLE, TAPING IF NECESSARY
ECONOBOARD WILL COMPRESS OR PUNCTURE UNDER LOW SURFACE AREA IMPACT
Technical Specifications
| Board Size | 1.2 x 0.6 |
|---|---|
| Board Area | 0.72m² |
| Thermal Conductivity | 0.033W/MK |
| Compressive Strength | 300 kpa |
| Water Absorption | 0.6% by vol. |
| STOCK CODE | THICKENESS (mm) |
| --- | --- |
| 6012 | 6 |
| 6014 | 10 |
Contact Us
sales@thermogroup.com.au
www.thermogroup.com.au
1300 368 631
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>