HWM-Water PermaNET Award Winning Leak Detection System User Manual
- June 9, 2024
- HWM-Water
Table of Contents
Water PermaNET Award Winning Leak Detection System
User Manual
Safety Warnings and Approvals Information.
This document applies to the following family of logger devices:
• Comlog 2/PermaNET+ | (CL///), (CP///), (PN///*). |
---|---|
• Multilog LX2 | (LX///*). |
IMPORTANT SAFETY NOTE:
This equipment uses a high strength magnet and should not be carried by or be
placed in the proximity of anyone with a heart pacemaker. This magnet can
permanently corrupt magnetic storage media such as floppy discs, hard discs
and tapes etc… It can also damage TV and PC monitor screens and some watches.
Carefully read the information in this document and on the packaging before
using the product. Retain all documentation for future reference.
SAFETY
- Refer to the “Important Safety Note” at the start of this document, regarding Heart Pacemakers.
- WARNING: When this equipment is being used, installed, adjusted or serviced this must be undertaken by suitably qualified personnel familiar with the construction and operation of the equipment and the hazards of any utility network.
- Contains a Lithium battery. Fire, explosion and severe burn hazard. Do not recharge, crush, disassemble, heat above100 °C, incinerate, or expose contents to water.
- CHOKING HAZARD – Contains small parts. Keep out of the reach of small children.
- Designed for outdoor use in areas that may become flooded resulting in the equipment becoming soiled. Wear appropriate protective clothing when installing or removing the product from the installation site. Protective clothing is also required when cleaning the equipment.
- Do not disassemble or modify the equipment, except where detailed instructions are given in the user-manual; Follow the instructions within the user manual. The equipment contains a seal to protect against water and moisture ingress. Water ingress may cause damage to equipment, including risk of explosion.
Use and Handling
-
The equipment contains sensitive parts that can be damaged by incorrect handling. Do not throw or drop the equipment or subject it to mechanical shock. When transporting in a vehicle, ensure the devices are secured and adequately cushioned, so they cannot fall and so that no damage can occur.
-
No user-serviceable parts inside, unless details are given in the user-manual. Follow the instructions in the user guide. The equipment must only be serviced or disassembled by the manufacturer or its authorised repair centre.
-
The equipment is powered by an internal battery which may present a risk of fire or chemical burn if the equipment is mistreated. Do not disassemble, heat above 100 °C, or incinerate.
-
Where an external battery is supplied, this also may present a risk of fire or chemical burn if the equipment is mistreated. Do not disassemble, heat above 100 °C, or incinerate.
-
Normal operating temperature: -20°C to +60°C. Do not expose to direct sunlight for prolonged periods. Do not mount on apparatus that can exceed this temperature range. Do not store above 30°C for prolonged periods.
-
The antenna must be attached to the unit before use.
Align the antenna connector and rotate the outer nut clockwise until it is finger-tip tight. Do not over-tighten. -
To prevent damage, put the logger into deep-sleep (storage) mode before disconnecting the antenna. Refer to the user-guide for instructions.
-
When carrying the equipment, hold it by its main body or carrying handle. Carrying the equipment by using attached cables or tubes can cause permanent damage and is not covered by warranty.
-
Store unused loggers in the original packaging. The equipment can become damaged by applying heavy loads or forces to it.
-
The equipment may be cleaned by use of a soft cloth lightly moistened with a mild cleaning fluid (e.g. a diluted domestic dish-washing liquid). A disinfectant solution may be used to sanitise if required (e.g. a diluted domestic disinfectant). For heavy soiling, gently remove debris with a brush (e.g. a domestic dishwashing tool, or similar). Ensure all connection points have a water-tight cover attached during cleaning, to prevent water ingress. When the connectors are not in use, keep the inside of the connectors clean. Do not allow liquid, moisture, or small particles to enter the equipment or connector. Do not pressure wash as it may damage the equipment.
Radiation Exposure Statement
- This equipment contains a radio transmitter and receiver. Use of antennas and accessories not authorised by HWM may void the compliance of the product and may result in RF exposures beyond the safety limits established for this equipment.
- When installing and using this product, maintain a 20 cm (or greater) distance between the antenna and the head or body of the user or nearby persons. Attached antenna must not be touched during transmitter operation.
Battery – Caution Points.
- The equipment contains a non-rechargeable Lithium Thionyl Chloride battery. Do not attempt to re-charge the battery.
- Where an external battery is supplied, this also contains a nonrechargeable Lithium Thionyl Chloride battery. Do not attempt to re-charge the battery.
- In the event of damage to the battery or the equipment, do not handle without appropriate protective clothing.
- Do not attempt to open, crush, heat or set fire to the battery.
- In the event of damage to the battery or equipment, ensure there is no risk of short-circuit whilst handling or shipping.
- Pack with non-conductive materials that give suitable protection. Refer to sections Waste Electrical and Electronic Equipment and Battery Directive. • If the battery fluid leaks, stop using the product immediately.
- If the battery fluid gets onto your clothes, skin, or eyes then rinse the affected area with water and consult a doctor. The fluid can cause injury and blindness.
- Always dispose of batteries in accordance with local laws or requirements.
Battery – Lifetime.
- The battery is single-use (not rechargeable).
- Do not store above 30 °C for prolonged periods, as this will reduce the life of the battery.
- The lifetime of the battery is limited. The equipment is designed to minimise power use from the battery, but this can vary according to the specific tasks it is given, its installation conditions and the operation of any 3rd-party equipment it communicates with. The equipment may re-attempt certain tasks (e.g. communication) if required, which decreases battery life. Ensure the equipment is installed correctly to maximise its battery life.
- Where the equipment has a facility to provide additional power, only batteries and / or parts supplied for the equipment by HWM should be used.
Waste Electrical and Electronic Equipment and the Battery Directive
Disposal and recycling: When the equipment or its batteries reach the end of
their useful life, they must be disposed of responsibly, according to any
applicable country or municipal regulations. Do not dispose of Waste
Electrical and Electronic Equipment or batteries as normal domestic waste;
they must be taken by the user to a separate waste collection point
designated for safe handling and recycling in accordance with local laws.
Waste Electrical and Electronic Equipment and batteries contain materials
that, when correctly processed, may be recovered and recycled. Recycling
product reduces the need of new raw materials and also reduces the amount of
material that is sent for disposal as landfill. Improper handling and
disposal can be harmful to your health and the environment. For more
information regarding where the equipment can be accepted for recycling,
please contact your local authority, recycling center, distributor or visit
the website http://www.hwmglobal.com/company-documents/.
Waste Electrical and Electronic Equipment.
HWM-Water Ltd is a registered producer of Electrical and Electronic Equipment
in the United Kingdom (registration number WEE/AE0049TZ).
Our products fall under category 9 (Monitoring and Control Instruments) of The
Waste Electrical and Electronic Equipment Regulations. We take all
environmental issues seriously and fully comply with the requirements for
collection, recycling and reporting of waste products.
HWM-Water Ltd is responsible for Waste Electrical and Electronic
Equipment from customers in the United Kingdom provided that:
The equipment was produced by HWM-Water Ltd (Palmer Environmental / Radcom
Technologies / Radiotech / ASL Holdings Ltd) and supplied on or after 13th
August 2005. or The equipment was supplied before 13th August 2005 and has
been directly replaced by HWM-Water Ltd products manufactured since 13th
August 2005.
HWM-Water products supplied after 13th August 2005 can be identified by the
following symbol: Under HWM-Water Ltd.’s Terms and Conditions of Sale,
customers are responsible for the cost of returning WEEE to HWM-Water Ltd and
we are responsible for the costs of recycling and reporting on that waste.
Instructions for returning Waste Electrical and Electronic Equipment: (1)
Ensure that the Waste Electrical and Electronic Equipment meets one of the
two conditions above. (2) The waste will need to be returned in accordance
with the regulations for transporting equipment with lithium batteries.
a. Pack the equipment in strong, rigid outer packaging to protect them from
damage.
b. Attach a Lithium Warning Label to the package.
c. The package must be accompanied by a document (e.g. consignment note) that
indicates:
i. The package contains lithium metal cells;
ii. The package must be handled with care and that a flammability hazard
exists if the package is damaged;
iii. Special procedures should be followed in the event the package is
damaged, to include inspection and repacking if necessary; and
iv. A telephone number for additional information.
d. Refer to the ADR regulations on shipping dangerous goods by road.
Do not transport damaged, defective, or recalled lithium batteries by air.
e. Before shipping, the equipment must be shut down. Refer to the User-Guide
of the product and any applicable utility software for guidance of how to
deactivate it.
Any external battery pack must be disconnected. (3) Return the Waste
Electrical and Electronic Equipment to HWM-Water Ltd using a licensed waste
carrier.
In accordance with the regulations, customers outside the United Kingdom are
responsible for Waste Electrical and Electronic Equipment.
The Battery Directive
As a distributor of batteries HWM-Water Ltd will accept old batteries back
from customers for disposal, free of charge, in accordance with the Battery
Directive.
PLEASE NOTE: All lithium batteries (or equipment containing lithium batteries)
MUST be packaged and returned in accordance with the relevant regulations for
transporting lithium batteries.
A licensed waste carrier must be used for transporting all waste.
For more information on Waste Electrical and Electronic Equipment compliance
or the Battery Directive please e-mail
CService@hwm-water.com or phone +44 (0)1633
489 479
Radio Equipment Directive (2014/53/EU):
-
Radio frequencies and Powers.
The frequencies used by the wireless features of this product are in the 700 MHz, 800 MHz, 850 MHz, 900 MHz, 1700 MHz, 1800 MHz, 1900 MHz and 2100 MHz ranges.
Wireless frequency band and maximum output power:
• GSM 700/800/850/900/1700/1800/1900/2100 MHz : less than 2.25W -
Antennas
Only antennas supplied by HWM should be used with this product.
Regulatory Compliance Statement:
Hereby, HWM-Water Ltd declares that this equipment is in compliance with the
following:
Radio Equipment Directive: 2014/53/EU and the relevant UK Statutory
Instruments requirements.
A copy of the full text of the UK and EU declarations of conformity is
available at the following URL: www.hwmglobal.com/product-
approvals/
HWM-Water Ltd
Ty Coch House
Llantarnam Park Way
Cwmbran
NP44 3AW
United Kingdom
+44 (0)1633 489479
www.hwmglobal.com
©HWM-Water Limited. This document is the property of HWM-Water Ltd. and must not be copied or disclosed to a third party without the permission of the company. Copyright reserved.
References
- Convenient Water Delivery Near You | Primo Water Delivery
- HWM | Energy Management, Pressure Control, Data Collection, Environmental Monitoring, Leak Detection,
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>