ella 32×72 Laydown Acrylic Alcove Bathtub Owner’s Manual

ella 32×72 Laydown Acrylic Alcove Bathtub

Technical Diagram

Install and Electrical

Protecting the Bath

Cover and protect the bath shell and fixtures from scratches or other damages during the
installation and tests. Remove the access panels when moving the acrylic alcove bathtub
and always lift the bathtub from the frame.

Electrical

The unit MUST be connected to a circuit protected by a ground fault circuit interrupter (GFCI) provided and installed by a licensed electrician and tested periodically (refer to instructions provided by GFCI manufacturer). Electrical requirements vary based on package; please refer to package diagrams included in the specifications. A licensed electrician for your area is required to install and test the electrical installation process. DO NOT use any kind of extension cords to power the unit.

Operating the pumps without first filling the bath to above the jets can cause permanent
damage to your equipment.

Push the GFCI “test” button into “reset” mode. If the GFCI fails to operate in this manner,

there is a ground current flow or a device malfunction, indicating the possibility of electrical shock. If this occurs, turn OFF the power and do not use the bathtub until the source of the problem has been identified and corrected.

Water Test

It is important to test that the Microbubble Pump is functioning properly before final in-wall installation to avoid unnecessary repairs or removal.

Electrical Requirements:

One (1) dedicated 120V electrical line with a 20AMP GFCI standard three prong outlet is required.

Front Access Panel and Reversible End Panel

Leveling Adjustments

Layout of adjustable leveling legs varies by model. This may not be an exact representation of how your tubs leveling legs are laid out. This is to be used as an example and to show that the legs need to be secured to the sub-floor.

Drain Installation

Make sure a watertight seal exists on all bath drain connections.

Tile Edge Installation

This acrylic bathtub does not include a tile flange, therefore we reccommend using the following:
https://www.amazon.com/American-Standard-9FLNG-TileFlange/dp/B003ZTP440

Cleaning and Maintenance

Recommended Acrylic Cleaners
Use only cleaning products whose labels state that they are SAFE for ACRYLIC.
Always test products on a small are of skirt before applying to complete bath area.

• White Vinegar & Water (Recommended)
• ZEP Professional strength shower tub & tile cleaner
• Dawn dish detergent
• Rubbermaid commercial strength shower tub & tile cleaner
• Home Depot HDX shower tub & tile cleaner
• Scrub free original soap scum remover
• Kaboom shower tub & tile cleaner with oxy clean
• Simple green all purpose cleaners (any scent)
• Simple green lime scale remover
• Simple green natural bathroom cleaner
• All telex products
• All Pine-Sol Products
• All Fragranzia Products

DO NOT USE the following on your
ACRYLIC Bath System. The use of the following chemicals will cause a dull surface or chemical cracks. The use of these products will VOID YOUR WARRANTY.

• Any product containing ammonia
• Dow scrubbing bubbles
• Abrasive Cleaners
• Ajax
• Comet
• Fantastic
• Soft Scrub
• Mr. Clean
• Nail Polish Remover
• Scouring Pads
• Ammonia
• Tough Act
• Powder or Crystal Drain Cleaners
• Griefworks Bathroom Cleaner
• Scrub Free w/Bleach
• Seventh generation bathroom cleaner – regular
• Magic Eraser

Monthly Maintenance

It is recommended that once a month the tub is flushed. As well, with every month of normal use, clean out the pumps inlet cover (shown right) by unscrewing the cover (counter clockwise) and removing any hair and debris from the cover and housing. Remount the cover in place. Never operate the system with the cover off, as the pump creates a strong suction and damage to the pump or injury may occur.

Cleaning and Maintenance

Recommended Acrylic Cleaners

Acrylic tubs provide customers with a better quality tub vs gel coat tubs. Unfortunately, these tubs can scratch if cleaned incorrectly. The way to proceed is gently, very gently. The good news: gentle cleaning does not translate into high maintenance. On the contrary, you’ll probably save some cash by foregoing pricey chemical cleansers. Here’s how to clean your acrylic tub safely and naturally: Wash your tub often, at least once a week, and use a mild soap — plain old dishwashing liquid is best — with lots of hot water. Most dirt will simply wash off with clean water. We recommend using liquid dish washing soap such as Joy, Palmolive or similar. Clorox bleach, Windex, ammonia based glass cleaners, Formula 409 and Fantastic are stronger cleaners that are also safe to use. Always clean with a soft sponge. Never, ever use abrasive cleaning products (those containing fine grit; check the label) or abrasive cleaning pads. Use of these chemicals will destroy the acrylic and void your warranty. Waxing is another no-no. Your acrylic tub is naturally very shiny and designed to stay that way without additional help. Lastly, is your water supply kind of alkaline? If so, you might notice a little hard- water buildup appearing over time. The easiest fix, believe it or not, is plain white vinegar. Spray a 50/50 mix of water and vinegar on the affected areas and let it soak for a while. Rub gently, then rinse.

If you would like a deeper clean than the recommended dish soap and hot water, you can try some of the products listed below that have been approved for use with Acrylic.

CLR PB-BATH-32PRO Multi Purpose Daily Bath Cleaner
Better Life Natural Tub and Tile Cleaner
Don Asiett’s Tub n Tile Concentrate
Better Life Natural Tub and Tile Cleaner
Bio Clean: Eco Friendly Hard Water Stain Remover
Rejuvenate Scrub Free Soap Scum Remover Non-Toxic Non-Abrasive Cleaning Formula
Spray Nine 26832 Heavy Duty Cleaner/Degreaser and Disinfectant

CLR PB-BATH-32PRO Multi Purpose Daily Bath Cleaner
Better Life Natural Tub and Tile Cleaner
Don Asiett’s Tub n Tile Concentrate
Better Life Natural Tub and Tile Cleaner
Bio Clean: Eco Friendly Hard Water Stain Remover
Rejuvenate Scrub Free Soap Scum Remover Non-Toxic Non-Abrasive Cleaning Formula
Spray Nine 26832 Heavy Duty Cleaner/Degreaser and Disinfectant

Hospital and Nursing Home Approved Bathtub Disinfectant

Customer Support

THEOCHEM LABORATORIES, INC. 7373 Rowlett Park Drive • Tampa, Florida 33610 •813-237-6463 • www.theochem.com
Emergency Response Number ChemTel Inc.1-800-255-3924

References

• Ellas Bubbles Walk In Tubs - Acrylic Bathtubs With Door
• Theochem Laboratories - Protect What Matters - Pro Cleaning Solutions

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>