FlyFishRC M8QMC-5883L GPS Module User Manual

June 10, 2024
FlyFishRC

FlyFishRC M8QMC-5883L GPS Module

Description

The FlyfishRC-MSQMC is a small size, fast positioning, easy-to-use GPS. It adopts 7 8*18mm RHCP ceramic patch antenna that provides excellent reception capability and a highly stable connectivity. The built-in QMC5883L high- precision magnetometer provides precise azimuth pointing, and the UBLOX7 o generation chip allows subtle altitude changes to be skipped for more stability. Ideal for use with FPV drones, multi-rotors, fixed wing and other model products.

Specification

  • GPS patch antenna size: 18 x 78 mm
  • Total dimensions: 20 x 20 x 71 mm
  • Weight: 8.8g
  • Input Voltage: 3.3V-5V, current 25mA
  • GPS pin definition: RX/TX UART
  • Compass pin definition: SDA/SLA

Wiring

FlyFishRC-M8QMC-5883L-GPS-Module-2

Setup GPS in Betaflight

  1. Enter the Ports tab in BF, select GPS in the Sensor input of UART4 and change the baud rate to 57600bps. Click Save.FlyFishRC-M8QMC-5883L-GPS-Module-3
  2. Enter the Configuration tab, enable GPS, select the UBLOX protocol, enable Auto baud rate and Auto config and click Save.(BF4.3 firmware version or above only).
  3. Reconnect the flight controller. For the GPS to work properly,an additional power supply may be needed. Plug your battery into your aircraft(please take off the props before plugging in LiPo), and pay attention to the BF status bar.The GPS icon will light up,indicating that the GPS is now “talking”to your flight controller.

Settings GPS RESCUE

  1. ln the Modes tab, add GPS RESCUE mode, and set your desired AUX channel.
  2. Enable Expert Mode in BF, go to the Failsafe tab and set the relevant parameters of GPS rescue.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals