EUROPLAST SPK2-100dB Kits Supply Valves With Sound Insulation Instruction Manual
- June 10, 2024
- EUROPLAST
Table of Contents
EUROPLAST SPK2-100dB Kits Supply Valves With Sound Insulation
Product Information
The SPK2-100dB and SPK2-125dB are sound insulation systems with a wall thickness range of 100-400mm. The system consists of an inside and outside grill, diffuser, filter, air duct, net against insects, and sound insulation material. The dimensions of the system are:
| A| B| C| D| d| E
---|---|---|---|---|---|---
SPK2-100dB| 175mm| 66mm| 400mm| 103mm| 70mm| 124mm
SPK2-125dB| 175mm| 66mm| 400mm| 128mm| 95mm| 151mm
Product Usage Instructions
To install the SPK2 sound insulation system, it is recommended to mount it high on the ceiling near a heat source. Follow these steps:
- Determine the wall thickness range of your installation location.
- Select the appropriate system model (SPK2-100dB or SPK2-125dB) based on the wall thickness range.
- Install the inside grill, diffuser, filter, air duct, net against insects, and sound insulation material according to the manufacturer’s instructions.
- Install the outside grill, diffuser, filter, and sound insulation material according to the manufacturer’s instructions.
Note: It is important to follow the manufacturer’s instructions carefully to ensure proper installation and optimal performance of the sound insulation system.
OVERVIEW
Description
- SPK2 is a kit that provides a natural airflow or exhaust from a room.
- This system is designed for installation in all room types. It is recommended to install the system near a heat source, high on the ceiling. This ensures mixing of the warm air with the air entering the room, thus ensuring maximum comfort. SPK2 is equipped with a valve, which can be adjusted with a string or a lever.
- SPK2 is provided with soundproofing materials that reduce indoor noise.
- SPK2 is equipped with EU1, which provides protection against dust and insects. All the elements are easy to remove and clean.
Installation
It is recommended to install the system high on the ceiling, near a heat source.
-
Creating a hole
When drilling a hole, the distance from the ceiling must be at least 15 cm. When drilling a hole, avoid hitting water pipes or electrical cables. The borehole must have a downward slope (1 mm / 100 mm) facing the outer wall. -
Installation of the external grille
To install the outdoor grille, the air duct must be cut slightly shorter than the thickness of the wall. Mount the outdoor grille with the air duct on the wall from the outside. The grille needs to be fixed using an adhesive for outdoor use. Use a sealant where it’s necessary. -
Installation of the internal grille
To install the internal grille, remove the decorative cover. Insert the grille into the air duct and secure it with four screws. Then replace the decorative cover. Use the lever to set the required flow rate.
Service
Filters need to be cleaned twice a year. Standard filters can be washed using soap water.
Granīta iela 32/k-6, Salaspils novads, Acone, Latvija, LV-2119
www.europlast.lv