Moda Fabrics PSRS2043-1 Milestone Panel Quilt Instruction Manual

: June 10, 2024
: Moda Fabrics

Table of Contents

cutting instructions
piecing instructions
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Moda Fabrics PSRS2043-1 Milestone Panel Quilt

cutting instructions

RS2045-12
Cut (1) 51/4″ WOF strip. Subcut (7) 51/4″ squares.
Cut (1) 41/2″ WOF strip. Subcut (4) 41/2″ squares.
Reserve remainder for binding

RS2049-15M
Cut (3) 51/4″ squares
Cut (12) 27 8 ” squares

RS2046-11M
Cut (3) 51/4″ squares
Cut (12) 27 8 ” squares

RS2047-11
Cut (28) 27 8 ” squares

RS2049-13M
Cut (20) 27 8 ” squares

RS2049-11M
Cut (5) 51/4″ squares

RS2043-11
Trim panel to 321/2″ x 401/2″.
You will end up trimming off the stripes long selvages.

piecing instructions

all seam allowances 1/4″ unless otherwise noted

MAKE FLYING GEESE

GENERAL INSTRUCTIONS: These are the general instructions for making flying geese 4 at a time. In the following section are the quantity requirements. See diagrams at top of next column. Collect (1) 51/4″ square and (4) 27 8 ” squares. Draw diagonal line on wrong side of all 27 8 ” squares. Place (1) 27 8 ” square in both upper left and lower right corners of 51/4″ square, right sides together (RST) and with outer edges aligned (smaller squares will overlap in middle). Pin. Stitch 1/4″ to either side of marked lines. Cut apart along marked lines and press small triangles away from larger triangle. Place one 27 8 ” square in remaining corner of one triangle unit, RST, with marked line as shown. Stitch 1/4″ to each side of line.

Cut apart along line and press smaller triangle away from larger. Repeat with other triangle unit and square for a total of 4 flying geese blocks. Trim off all seam allowance points. Blocks should measure 21/2″ x 41/2″.
piecing instructions

Using the previous instructions, make the following number of flying geese blocks (NOTE: Don’t fret about print direction, all the prints will be going multiple ways in the finished quilt):

MAKE SIDE BORDERS

Piece (4) columns of (10) flying geese as shown below. Press seams towards end with yellow fabric.
Join sets of (2) columns into (2) units as shown. Press seam open.

MAKE TOP & BOTTOM BORDERS

Piece (4) rows of (8) flying geese as shown below. Press seams towards ends with teal fabric.
Join sets of (2) rows into (2) units as shown. Press seam open.

To both short ends of each border, join a 41/2″ gray square. Press seams towards squares

ASSEMBLE

Join side borders to side edges of panel. Press seams towards panel.
Join top and bottom borders to top and bottom. Press seams away from panel. Baste, quilt and bind as desired. Binding yardage is for 21/2″ crossgrain binding.

You did it! You made a milestone panel quilt!!
Be sure to use #rubystarsociety, #sarahwattspanel and #birthdayfabric when sharing your creations so we can see them!

Use Sarah Watt’s Milestone panel to make this adorable baby quilt. Use it as a photo backdrop to track baby’s first year of life.
All fabrics are from Birthday by Sarah Watts for Ruby Star Society.

fabric requirements

RS2045-12
3/4 yd (includes binding