HALCYON P450 1PNLMDS Sensor Highbay Instruction Manual

HALCYON P450 1PNLMDS Sensor Highbay Instruction Manual

DEFAULT SETTINGS

NOTE: The sensor highbay is preset to the following factory settings.

• 100% Detection Range (14m x14m)
• 10 Minute Hold time (on time)
• Daylight Sensor 400 lux
• Standby Period 5 minutes
• Standby Dimming level 50%

Explanation:

When the ambient light level is less than 400 lux the highbay will stay on at full power for 10 minutes when the motion sensor is triggered, after that it will dim to 50% for 5 minutes before turning off. Each time motion sensor is triggered timer resets to 10 minute countdown.

If the ambient light level is greater than 400 lux the highbay can not be triggered by motion and will remain off (adjust daylight sensor as per below to change this setting)

DAYLIGHT SENSOR SETTINGS SHORTCUT
To adjust the lux sensor parameters simply press desired lux setting whilst pointing remote at sensor, highbay will blink 3 times to show it has saved the new lux setting.

See next page for more details

Sensor technical Specification

ON / OFF
Press to enter Highbay into constant ON operation mode e.g. standard wall switch operation.

Note: DOES NOT MEAN ON/OFF OF HIGHBAY OR REMOTE CONTROL

EXIT
Press exit to exit the ON / OFF operation mode Highbay will blink 3 times to confirm.

DEFAULT
Press to reset the sensor settings to default.

LOCK/UNLOCK
Press to lock / unlock the remote control.

HOLD LEVEL
Press A to increase the brightness of the Highbay during the “standby period”. Press V to decrease brightness

AMBIENT LUX LEARNING
Press to set the current ambient brightness as the lux setting

LUX DISABLE
Turn off the light sensor function for a motion only sensor

HOLD TIME (“On” time)
Choose 30s, 1min, 5min, 10min or 30min. Hold time is the amount of time the highbay stays on for after being activated from motion or ambient light levels. (Default – 10 Minutes)

TEST MODE
When test mode is pressed the highbay will stay on for 2 seconds, dim for 2 seconds, standby for 2 seconds before switching off. If motion is detected the timer will restart. After a complete cycle test mode will exit automatically back to chosen settings.

STANDBY PERIOD
Choose Os, 10s, 1min,10min or 30min. Standby period is entered after chosen hold time is up (if motion has not been activated) (Default – 5 minutes)

STANDBY DIMMING LEVEL
Choose 10%, 30% or 50%, this will set the brightness of the highbay when in standby mode (Default – 50%)

DETECTION RANGE
100% = 14m detection range
50% = 7m Detection Range
(Default – 100%)

Manual Dipswitch Override:

If the remote is misplaced or damaged the Sensor settings can also be set using the dipswitch inside the sensor housing, any change to these settings will alter the default settings outlined

Detection Range

Hold Time

Daylight Sensor

Standby Period

Standby Dimming Level

Documents / Resources

| HALCYON P450 1PNLMDS Sensor Highbay [pdf] Instruction Manual
P450 1PNLMDS Sensor Highbay, P450 1PNLMDS, 1PNLMDS Sensor Highbay, Sensor Highbay
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>