ADJ 520-00019 Platinum Wireless Kit User Manual

ADJ 520-00019 Platinum Wireless Kit

OVERVIEW

Mouse features

1. Left Click Button
2. Right Click Button
3. Scroll Wheel
4. DPI Switch Button

The product image is only indicative

Keyboard features

1. Music player
2. Decrease volume
3. Increase volume
4. Mute volume
5. Previous
6. Next
7. Pause/Play
8. Stop
9. Navigate to Internet home
10. Mail
11. Computer
12. Save as

Troubleshooting

1. Wireless mouse press the DPI button to change the precision as your needs.

2. If the battery power is going to run up of the mouse, please replace it with 1 new battery.

3. Trying moving the keyboard and mouse closer to the USB nano receiver. (Distance Range:10M)

4. If the keyboard power LED flashes 3s and then goes out occasionally (Low power indicating) or no indicator light when turning on the keyboard, please replace the batteries with new ones; or it will disconnect or the response lag.

5. Plug your nano receiver into some other USB port of your PC or laptop.

6. Put the battery into the mouse and keyboard in the right direction.

7. The keyboard loses connection with the nano receiver
   If the power LED on the keyboard glows for 3s and then goes off, but your keyboard input is not recognized, it means the keyboard’s connection to the nano-receiver has been lost. Please follow the instructions below step by step to reconnect:

8. Turn off the keyboard

9. Take the nano receiver out from the USB port

10. Press the ESC +Q keys at the same time, then slide the switch to the ON position, and the power LED flashes for 5 seconds (the keyboard is activated).
    You have 5 seconds to plug and pair the receiver.

11. Plug the nano receiver back into the PC or laptop
    If the Power LED flashes for 3 seconds, pairing succeeds, and if it blinks for 5 seconds, the connection failed. Repeat the pairing twice or three times if the connection is not made on the first try.
    Very important:
    Please make sure press ESC +Q before you turn on keyboard;
    The LED flashes for 5s for the search, please make sure you connect the receiver to the PC during the search. When the LED dies, it means that the search is finished. If no connection is established, repeat the step -again.
    Power LED flashes red only for 3s and then goes off and the keyboard does not respond. The keyboard function is normal. All you have to do is reconnect to the receiver. Please follow the connection procedure described above.

12. If the red sensor LED on the button of the mouse keeps flashing but the cursor does not move, please try to pair it again as below steps:

13. 1. Pull out the receiver

14. Turn off the mouse

15. Then slide the switch to the ON position; the mouse is in resourcing status

16. Plug the receiver back to pc or laptop

What’s in the box

1. 1xwireless keyboard
2. 1xwireless mouse
3. 1xUSB nano receiver
4. User manual

Warranty

This product is guaranteed against any manufacturing defect, based on the D.Lgs. February 2, 2002, No 24.
In case of failure, please contact the retailer where you purchased it. You can be found at www.adj.it for standards guarantee.

This product complies with the following directives
DIRECTIVE 2014/53/EU on the harmonisation of the laws of the Member States relating to the making available on the market of radio equipment;
DIRECTIVE 2011/65/EU on the restriction of the use of certain hazardous substances in electrical and electronic equipment.
The declaration of conformity for this product is visible on www.adj.it site, on the product page.

The symbol of the crossed-out trash indicates that the product, at the end of its useful life, must be treated separately from domestic waste and must be taken to a recycling center for electrical and electronic equipment or delivered to the seller when buying a replacement. The separate waste collection contributes in preventing possible adverse effects on the environment and health and promotes the recovery of materials it is made. You are responsible for assigning the equipment in question at the appropriate waste disposal center. For more detailed information contact your local waste disposal service or the shop where it was purchased. Anyone who does not carry the product in a recycling center for electrical and electronic waste shall be punished with an administrative penalty provided by law on the illegal disposal of waste.

Additional compliance information:
To obtain additional information about compliance, go to the ADJ website: www.adj.it/certificationor contact ADJ Customer Support to the following e-mail address: supporto@adj.it
Made in China Imported and distributed by loT Tecnologie s.r.l.
Via della Faeta, 1 – 00030 San Cesareo (ROMA) – Italy

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>