HALCYON LED440 20W 2FT LEDE Batten Select 4K-6K Instruction Manual
- June 10, 2024
- HALCYON
Table of Contents
HALCYON LED440 20W 2FT LEDE Batten Select 4K-6K
INSTALLATION INSTRUCTIONS
- Product Name: LED Batten Light
- Model #: LED440 N, LED440 DL, LED441 N, LED441 DL, LED442 N LED442 DL
- Description: 20 Watt LED, Non-dimmable, IP20, 4000K/ 6000K
- 40 Watt LED, Non-dimmable, IP20, 4000K/ 6000K
- 60 Watt LED, Non-dimmable, IP20, 4000K / 6000K
- Rated Voltage: 220-240V-, 50/60HZ
- Switch off power,
- Remove caps, unscrew diffuser and remove.
- Fasten chassis to surface.
- Re-connect driver connection and wire terminal block as indicated.
- Fasten diffuser to chassis.
- Replace caps.
- Switch luminaire on to test luminaire functions correctly and is electrically safe.
WARNING: FIRE RISK EXISTS IF THE LAMP IS COVERED BY OR POSITIONED CLOSE TO CURTAINs OR OTHER COMBUsTIBLE MATERIALS
- Installation note: Do not install on the same circuits as Metal halide, Fluorescent and other “Low power factor” devices.
- When installed on the same circuit it can cause flickering and/or premature failure of the “high power factor electronic drivers.
- The harmonic distortion from low power factor devices alters the Waveform of the AC supply which can cause componentry in high power factor electronic drivers to resonate, run over temperature and fail after prolonged exposure.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>