Axis Communications AXIS Q6318-LE PTZ Camera Instruction Manual
- June 10, 2024
- AXIS COMMUNICATIONS
Table of Contents
Axis Communications AXIS Q6318-LE PTZ Camera Instruction Manual
Impact on warranty
This product is approved for repaint by Axis, provided that you follow the instructions in this document and at axis.com/warranty-implication- when-repainting.
Risks with repainting
There are several risks when disassembling or assembling an Axis product. There is always a certain yield loss during assembly. Training of operators and the use of correct tools mediates some of the problems but they can never be fully avoided. Some of the risks include:
ESD Damage – Always handle the product in an ESD safe environment. Even if precautions are taken there is always a risk of ESD damage. The damage can remain undetected and cause problems during the lifetime of the equipment.
Dust contamination – Opening a camera may expose the lens and sensor to dust or paint. Dust will affect the optical performance.
Lenses need to be disassembled in a dust-free environment, preferably a cleanroom.
Paint overspray – Masking the different components of the equipment is critical.
Failure to mask sensitive areas can cause problems with assembling the equipment. Any areas that are not painted at factory or have a different surface treatment than the rest of the parts (threads, ground and electrical contact surfaces) must also be masked to ensure function.
Repaint the product
Preparations
- If applicable, disassemble the device according to the instructions in this document.
- Clean all parts that will be repainted thoroughly to remove grease, dust, or oil.
- To ensure reassembly and functionality of the product, mask any openings (for example for screws, LED indicators, or microphones) before you paint.
Pretreatment of parts
Depending on the part material and type of paint applied at factory, different
pretreatment should be done for the new paint to adhere as well as possible.
Clean the parts properly to remove oil, grease and dust.
Powder coated parts – Use a primer. Alternatively, remove the original powder coating down to the base material, using fine sandpaper, and clean the parts before painting. Anodised and chromated parts – Use a primer.
Uncoated stainless steel – No special pretreatment is needed, but make sure that the surface is clean before painting.
Plastic – Use a primer.
Material used in product
The material used in the product are:
- Chassis: Aluminium EN AC-43400
- Top of the weather shield : ASA Luran S 797SEUV
- Bottom of the weather shield: PA+GF Grilamid LV-3H(GF30)
Disassembly
Repainting
Repainting Instructions
a Date: July 2022
© Axis Communications AB, 202
Ver. M2.3
Date: July 2022
Part No. T1 0178604
References
- Axis Communications - Leader in network cameras and other IP networking solutions | Axis Communications
- Learning | Axis Communications
- Patent statement | Axis Communications
- Welcome to Axis support | Axis Communications
- Warranty implication when repainting | Axis Communications
- License - APSL
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>