thermaltake Toughpower GF1 TT Premium Edition ATX 80 Gold Power Supply Unit User Manual
- June 4, 2024
- thermaltake
Table of Contents
thermaltake Toughpower GF1 TT Premium Edition ATX 80 Gold Power Supply
Unit
Warnings and Caution
- Do not unplug the AC power cord when the power supply is in use. Doing so may cause damage to your components.
- Do not place the power supply in a high humidity and/or temperature environment.
- High voltages exist in the power supply. Do not open the power supply case unless you are an authorized service technician or electrician. Doing so will void the warranty.
- The power supply should be powered by the source indicated on the rating label.
- Please use only genuine Thermaltake modular cables with Thermaltake Cable Management power supply models.Third party cables might not be compatible and could cause serious damage to your system and power supply. The warranty is voided with the use of third party cables.
- All warrantees and guarantees will be voided, if failure to comply with any of the warnings and cautions covered in this manual.
Components Check
- TOUGHPOWER GF1 power supply unit
- AC power cord
- U ser manual
- Mounting screws x 4
- Cable straps x 4
Power Connector Introduction
Output Specification
Installation Steps
Note: Make sure that your system is turned off and unplugged. Disconnect the AC power cord from your old power supply.
-
Open your computer chassis; please refer to the instruction manual provided with your chassis.
-
Install the PSU into the case with the four screws provided.
-
If your motherboard requires a 24pin Main Power connector,
please connect the 24pin Main Power connector to the motherboard. -
For a motherboard that only requires a 4pinATX 12V (CPU) connector, please detach a 4pin connector from the 4+4pin ATX 12V connector and connect itto the motherboard.
(Either one of the 4pin from the 4+4pin ATX 12V connector will work) For a motherboard that requires a single Bpln EPS connector, please use the 4+4pln connector from the power supply. -
Connect other peripheral power connectors to devices such as hard drives,optical drives, etc.
-
lf your graphlc card requires PCI-E power connector, please connect the corresponding PCI-E
connector instructed by your graphic card’s user manual. Please note the power supply utilizes a unique 6+2pin PCI-E connector that can be effectively uaad as a single 8pin or Spin PCI-E connector. To uae it aa a Spin PCI-E connector, plaaae detach the 2pin connector from th& 6+2pln connector. -
Close your computer case and connect the AC power cord to the power supply AC Inlet
-
Attention! When Smart Zero Fan System is turned on, the fan will not operate until the power supply reaches approximately 30% of rated load; It is normal if the fan does not operate when computer is at a low working load.
TOTAL PROTECTION
-
Short Circuit Protection
A ctivated when any DC rails short-circuited. -
Over Power Protection
The power supply shall be shut down and latch off, if the wattage of the power supply is 120% ~ 150% over continuous power.
EMI & SAFETY
Trouble-Shooting
If the power supply fails to function properly, please follow the troubleshooting guide before applying for service:
- Is the power cord plugged properly into electrical outlet and into the power supply AC inlet?
- Please make sure the I/O switch on the power supply is switched to I position.
- Please make sure all power connectors are properly connected to all the devices.
- If connected to a UPS unit, is the UPS on and plugged in?
If the power supply is still unable to function properly after following the above instruction, please contact your local store or Tt branch office for after sales service. You may also refer to Thermaltake’s website for more technical support: thermaltake.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>