optix RVC1150-T Top-Bottom Mount Camera User Guide
- June 10, 2024
- OPTIX
Table of Contents
MODEL : RVC1150/T
Top/Bottom Mount **Camera
QUALITY
PRODUCTS FOR THE PROFESSIONAL INSTALLER
**
INTRODUCTION
Congratulations on your purchase of the Optix “Top or Bottom View Camera”.
With camera installed, you are able to have a great visual of what is on the
behind your vehicle while driving or going in reverse.
Contents:
1- Camera Bottom or Top
1- Hole saw
1- Hardwire plug
1- Power Plug 
INSTALLATION/QUICK START
- These cameras are top or bottom cameras depending on part number. Angles can not be adjusted, there for they can only be mounted upside down or right side up. Most installers like to mount this right above the license plate or on the very top of the vehicle. This is an OEM like camera and mounting is up to customer’s preference.
- Route wires into the vehicle and attach the video wire to your DVR, Splitter, Switcher or directly to your monitor. Make sure cables are not being pinched. If you purchased the RVC1150T you have a pair of wire loops on the camera wire. Please use the notes bellow to assist you with functions of those loops.
RVC1150T LOOPS:
Green cut – Lines
Green not cut – No lines
White cut – Upside down view / Top mount
White not cut – Normal view / Bottom mount 
Camera Specifications:
- Works with PAL and NTSC
- 120 degree viewing angle
- IP67-IP68 Water-Proof
- 0.2 Lux/F 1.8
- Current Cosumption 300mA
Accele Electronics will not be responsible for damages caused to your car due to improper installation. For complete owners manual please visit https://accele.com/product/t-rvc1150-t/ Thank you for being a valued customer of ACCELE ELECTRONICS