Danfoss Aero RA Click Remote Sensor Installation Guide
- June 10, 2024
- Danfoss
Table of Contents
Danfoss Aero RA Click Remote Sensor
Product Information
Thermostatic Sensors Series
The thermostatic sensors series is designed to regulate the temperature of a heating system. The product comes with code numbers 013G1246 and 013G1236, and blind mark identification AN446460676612en-000101. The product has a maximum range of 0-2m and can be set at a maximum value of 4 and a minimum value of 2.
Product Usage Instructions
- Before installing the thermostatic sensors series, ensure that the heating system is turned off.
- Locate the desired position to install the thermostatic sensor. It should be installed on the return pipe and away from the heat source.
- Use the blind mark identification AN446460676612en-000101 to align the sensor with the correct installation position.
- Connect the thermostatic sensor to the heating system using code numbers 013G1246 or 013G1236 depending on your system.
- Set the desired temperature range by adjusting the maximum and minimum values. For example, if you want to set a maximum temperature of 4 degrees Celsius, turn the dial until you see “MAX=4” on the display. Similarly, if you want to set a minimum temperature of 2 degrees Celsius, turn the dial until you see “MIN=2” on the display.
- Turn on the heating system and monitor the temperature to ensure that it stays within the desired range.
For further information or assistance with installing and using the thermostatic sensors series, please refer to the full user manual or contact our customer support team.
Installation
BIV Installation
Uninstall
Remote sensor
Temperature Limitation
Theft protection
Blind mark
Danfoss A/S
Climate Solutions danfoss.com +45 7488 2222 Any
intormation, including, but not limited to information on the selection ot
product, its application or use, product design, weight, dimensions, capacity
or any other technical data in product manuals, extent. explicit reference is
made in a quotation or order confirmation. Danfoss cannot accept any
responsibility for possible errors in catalogs, brochures, videos, and other
material. Danfoss reserves the right to alter its products without notice.
This also applies to products ordered but not delivered provided that such
alterations can be made without changes to the form, fit or function of the
product. All trademarks in this material are property of Danfoss AS or Danfoss
group companies. Danfoss and the Danfoss logo are trademarks of Danfoss A/S.
All rights reserved.Danfoss Climate Solutions | 2023.03
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>