EBTOOLS Mini Thermal Print Kids Camera 12 Million Pixels User Manual

Mini Thermal Print Kids
Camera 12 Million Pixels
User Manual

Description of keys and locations:

Installing and taking out a Micro SD card (memory card):

1. Insert a Micro SD card into the card slot as shown below. (Note: You need to prepare any Micro SD card by yourself)
2. The card will be horizontally placed in the machine after it is installed properly.
3. It can be ejected quickly by pressing the card slot inwards.

Installing printing paper:

1. Open the paper chamber at the paper chamber gate;
2. Put printing paper into the chamber as shown in the figure and reserve a length of about 30mm;
3. Cover the chamber; the cover and the machine make a flat surface after it is properly installed, and a small part of the printing paper is outside the cover.

Startup & shooting:

1. Long press (6) to power it on or off; after the startup, slightly press (6) to switch the front and rear cameras.
2. Find a view as per the screen.
3. Slightly press (5) to take pictures; press (5) for 2 seconds to make a video, and press (5) to save the video and exit the video mode.
4. Slightly press (2) to switch to print mode; slightly press (5) to take and instantly print pictures.

Album and deletion:

1. Slightly press (3) to enter the album interface, and press (3) again to exit the interface.
2. In the interface, press (7) to print or delete pictures; press (5) to confirm the operation and press (7) to cancel it.

Setup and formatting:

1. Slightly press (7) to enter setup mode; in the setup mode interface, press (7) to exit the mode.
2. In the setup interface, click (1) & (4) to choose different settings, including picture quality, time-lapse shooting, language, date & time, sound, formatting, and printing concentration. (All files will be cleared if formatting is performed. Please operate it carefully.)
3. Press (5) to confirm any operation and press (7) to cancel it.

Copying files to a computer:

1. Connect the camera and a computer by using a data cable to copy or delete files in the computer.

Instructions:

1. In case of any problem, please use the steel needle to press the reset key for resetting. More than 80% of problems can be solved by resetting. Don’t dismantle it without authorization to avoid dangers and invalid warranty services.
2. In case of low battery, please insert the dedicated USB cable into a 5V power adapter or a computer USB port for charging. You need to prepare such power adapter by yourself.
3. Don’t drop or squeeze the camera to avoid damaging the interior electronic components.
4. The camera is not a waterproof electronic product. Don’t expose it to any humid conditions.
5. A warranty card is included in the package. Please keep it properly for future warranty services.
6. Disconnect the USB cable before using any liquid to clean it.
7. The wire, plug, shell, and other parts of the transformer or battery charger must be inspected on a regular basis. Stop using it if any damage is found until it is fully repaired. Don’t use any inferior charger for charging.
8. Only any of the recommended transformers can be used for charging. The transformer is not a toy. Don’t let children charge the camera.

Warning! The camera contains small parts, and it’s not suitable for children under 3 years.

We provide free maintenance of six months since the purchase date for the product. Before sending it for repairing, please reset it or restart it.
If your problem remains unchanged, please contact our customer service to find out the cause.
The following conditions are not included in the scope of our free maintenance services:

1. Any failure or damage caused due to incorrect operation or maintenance.
2. Any damage due to any of accidental or man-made factors.
3. The camera is dismantled without authorization for repairing.
4. The warranty period is expired.
5. Any abrasion, corrosion, or fading during normal operation.

Troubleshooting:

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>