standivarius Oryx Laptop Stand User Manual
- June 10, 2024
- standivarius
Table of Contents
standivarius Oryx Laptop Stand
Product Information
The Oryx is a laptop/document stand designed to provide comfort and ergonomics while using your laptop or reading documents. It features four height settings and a rear support that can be unfolded to form a laptop/document holder. Additionally, the stand comes with a U-shaped gel tab that can be attached to your tablet to keep it in place while using the stand. The gel tab is reusable and leaves no residue. However, it is important to ensure that your device is properly secured at all times.
Product Usage Instructions
- Push the stand to form a laptop/document support.
- Unfold the rear support.
- Select one of the four height settings.
- Place your laptop or document on the stand to view.
- If using a tablet, you can attach the included U-shaped gel tab to keep it in place. The tab can be gently eased off if needed by sliding a credit card between the gel and the tablet. If the gel loses its stick, rinse it in water, air-dry it, and reuse it.
- Ensure that your device is properly secured at all times while using the stand.
Note : DMR Ergonomics does not accept liability for any damage to your device resulting from improper use of the stand.
For more information, visit www.standivarius.com
Assembling Instruction
Laptop:
-
Push to form laptop/document support
-
Unfold rear support.
-
Select one of four height settings.
-
Place laptop and document on stand to view
Tablet
-
Remove the transparent protective film from U- the shaped tab and stick firmly to the back of the tablet on the centre line approximately 5 cm from the bottom. (Tip: use measure on the side of this sheet printed at real size, no scaling)
-
Follow steps 2 & 3 above and set up the stand on the highest setting. Extend the tablet support and place tablet in position.
-
Push out the retaining tongue on the stand, fold down the end section and tuck it down into the U-shaped tab.
-
Position the stand on your desk about an arm’s length away. Add an external mouse and keyboard to create an ergonomic workstation
Important – read before use
Tablet height/angle
- The tablet height can be raised and lowered using the four settings on the stand; the screen viewing angle can be adjusted by changing the position of the U-shaped tab on the table
- The ideal viewing angle will depend on user preference as well as the thickness of the tablet, so we suggest starting with the tab in the position shown in step 5 and moving it down the tablet by up to 2 cm to adjust the angle. (Tip: watch assembly video: standivarius.com/oryx-pro). When using tablets in portrait orientation, the lower laptop support may offer better stability than the upper tablet support.
Removing U-shaped tab
The U-shaped tab can be left on the tablet or gently eased off.
( Tip : Slide a credit card between the gel and the tablet to ease the tab
off). The reusable nano PU gel leaves no residue and has high strength and
viscosity, but if it loses its stick, then simply rinse in water, air-dry, and
reuse. A spare tab has been included with this product for your convenience.
Safety:
The gel tab is a tested method of retaining the tablet on the stand, but it remains the user’s responsibility to ensure that the device is properly secured at all times. DMR Ergonomics does not accept liability for damage to any device as a result of improper use of this stand.
References
- Oryx Pro - hybrid laptop / tablet stand - standivarius workplace ergonomics
- Mobility for the hybrid office - Ergonomic laptop stands - standivarius workplace ergonomics
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>