AEG DGE5660HM Cooker Hood User Manual
- June 10, 2024
- AEG
Table of Contents
DGE5660HM
DGE5860HM DGE5160HM
User manual Cooker Hood
User Manual
DGE5660HM Cooker Hood
FOR PERFECT RESULTS
Thank you for choosing this AEG product. We have created it to give you
impeccable performance for many years, with innovative technologies that help
make life simpler –
features you might not find on ordinary appliances. Please spend a few minutes
reading to get the very best from it.
Visit our website for:
Get usage advice, brochures, trouble shooter, service information: www.aeg.com
Register your product for better service: www.registeraeg.com
Buy Accessories, Consumables and Original spare parts for your appliance: www.aeg.com/shop
CUSTOMER CARE AND SERVICE
Always use original spare parts.
When contacting our Authorised Service Centre, ensure that you have the
following data available: Model, PNC, Serial Number.
The information can be found on the rating plate.
Warning / Caution-Safety information
**** General information and tips
Environmental information
Subject to change without notice.
SAFETY INFORMATION
**** For your safety and correct operation of the appliance, read this manual
carefully before installation and use.
Always keep these instructions with the appliance even if you move or sell it.
Users must fully know the operation and safety features of the appliance.
The wire connection has to be done by specialized technician.
-
The manufacturer will not be held liable for any damages resulting from incorrect or improper installation.
-
The minimum safety distance between the cooker top and the extractor hood is 650 mm (some models can be installed at a lower height, please refer to the paragraphs on working dimensions and installation).
-
If the instructions for installation for the gas hob specify a greater distance, this must be respected.
-
Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood.
-
Means for disconnection must be incorporated in the fixed wiring in accordance with the wiring rules.
-
For Class I appliances, check that the domestic power supply guarantees adequate earthing.
-
Connect the extractor to the exhaust flue through a pipe of minimum diameter 120 mm. The route of the flue must be as short as possible.
-
Regulations concerning the discharge of air have to be fulfilled.
-
Do not connect the extractor hood to exhaust ducts carrying combustion fumes (boilers, fireplaces, etc.).
-
If the extractor is used in conjunction with non-electrical ap- pliances (e.g. gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. When the cooker hood is used in conjunction with appliances supplied with energy other than electric, the negative pressure in the room must not exceed 0,04 mbar to prevent fumes being drawn back into the room by the cooker hood.
-
The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels.
-
If the supply cord is damaged, it must be replaced from the manufacturer or its service agent.
-
Connect the plug to a socket complying with current regula- tions, located in an accessible place.
-
With regards to the technical and safety measures to be adopted for fume discharging it is important to closely follow the regulations provided by the local authorities. WARNING: Before installing the Hood, remove the protective films.
-
Use only screws and small parts in support of the hood.
WARNING: Failure to install the screws or fixing device in accordance with these instructions may result in electrical hazards. -
Do not look directly at the light through optical devices (binoculars, magnifying glasses…).
-
Do not flambè under the range hood; risk of fire.
-
This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concern- ing use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
-
Children should be supervised to ensure that they do not play with the appliance.
-
The appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction.
Accessible parts may become hot when used with cooking appliances. -
Clean and/or replace the Filters after the specified time period (Fire hazard). See paragraph Care and Cleaning.
-
There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels (not applicable to appliances that only discharge the air back into the room).
-
The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product.
USE
- The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells.
- Never use the hood for purposes other than for which it has been designed.
- Never leave high naked flames under the hood when it is in operation.
- Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides.
- Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames.
CARE AND CLEANING
– The Grease filters must be cleaned every 2 months of operation, or more
frequently for particularly heavy usage, and can be washedin a dishwasher (Z).
– The Activated charcoal filter is not washable and cannot be regenerated, and
must be replaced approximately every 4 months of operation, or more
frequently for particularly heavy usage (W).
– Control lights, if present.
- Clean the hood using a damp cloth and a neutral liquid detergent.
CONTROLS
Button | Function | Led |
---|---|---|
L | Turns the lights on/off at maximum strength. | – |
T1 | Tums the motor on/off at speed one. | Fixed. |
T2 | Turns the Motor on at speed two. | Fixed. |
Press and hold the button for approximately 3 seconds, with all the loads
turned off (Motor and Lights), to turn the Activated Charcoal Filter alarm on.
The relevant LED flashes twice to confirm. To turn the alarm off, press the
button again and hold for at least 3 seconds. The relevant LED flashes once.|
–
T3| Turns the Motor on at speed three.| Fixed.
Press and hold the button for approximately 3 seconds, with all the loads
turned off (Motor and Lights), to perform a reset. The LED S1 flashes three
times.| –
T4| Turns the Motor on at INTENSIVE Speed.| Fixed.
This speed is timed to run for 6 minutes. At the end of this time, the system
returns automatically to the speed that was set before. If it is activated
with the motor turned off, the hood will switch to OFF at the end of the time.
Press and hold for 3 seconds to enable the remote control, indicated by the
LED flashing twice.
Press and hold for 3 seconds to disable the remote control, indicated by the
LED flashing just once.| –
S1| Signals the Metal Grease Filter saturation alarm, indicating that it is
necessary to wash the filters. The alarm is triggered after the Hood has been
in operation for 100 working hours.| Fixed.
When this is activated, it signals the Activated Charcoal Filter saturation
alarm, indicating that the filter must be changed; the Metal Grease Filters
must also be washed. The Activated Charcoal Filter saturation alarm comes into
operation after the Hood has been working for 200 hours.| Flashing.
REMOTE CONTROL
The remote control is powered by a CR2032 type 3 V battery (not included).
- Do not place the remote control near heat sources.
- Do not discard the batteries with normal waste, they must be put into the specific containers.
**** | **** | Turns the motor On and Off. |
---|---|---|
– | ||
– | ||
Turns the lights On/Off. | ||
Activates the Intensive function. | ||
– | ||
+ | Increases the working speed of the |
motor.
–| Decreases the working speed of the
motor.
LIGHTING
- For replacement contact technical support (“To purchase contact techni- cal support”).
**** 991.0554.501_02 – 211124
D00004962_01
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>