mptech TS-4312 Vibrating Body Massager User Manual

mptech TS-4312 Vibrating Body Massager

EN © 2021 HYKKER All Rights Reserved

Equipment delivery location: mPTech Sp. z o.o. Krakowska street 119
50-428 Wrocław
Poland
Designed in Poland Manufactured in China

Manufacturer:
mPTech Sp. z o.o. Nowogrodzka 31 street 00-511 Warsaw Poland
Helpline: (+48 71) 71 77 400
E-mail: [email protected]
www.myphone-mobile.com

Safety of use

WARNING!
The surfaces of the unit can become very hot! Please be careful when using!

Read these guidelines carefully. Not following them may be dangerous or illegal.

• CHILDREN
  Keep the device, its accessories and packaging out of reach of children. Cables and plastic packaging may wrap around the child’s neck or be swallowed, resulting in suffocation or choking.

• DO NOT RISK
  Do not use the device near flammable fabrics. Do not use the product with a damaged body or accessories. The product is not intended for use on animals. Do not use the device for purposes other than massaging body parts.

• QUALIFIED SERVICE
  This product may only be repaired by qualified service personnel of the manufacturer or by an authorised service centre. Repairing the device by an unqualified or unauthorized service technician may result in damage to the device and void the warranty. The manufacturer is not responsible for problems caused by unauthorized modifications to the equipment made by the user.

• PHYSICALLY OR MENTALLY DISABLED PEOPLE
  This device should not be operated by people (including children) with limited physical or mental abilities, as well as by people with no earlier experience in operation of electronic equipment. They may only use it under the supervision of persons responsible for their safety after they have read and understood the instructions for safe use.

• WATER AND OTHER LIQUIDS
  Protect the device from water and other liquids. Avoid using the device in environments with high humidity like kitchens or bathrooms. Water particles may cause moisture to appear in the device, which adversely affects the electronics and may cause damage to the equipment.

• SURROUNDINGS
  The device should not be used in dusty conditions. Connect the unit so that it cannot be damaged or endanger people or animals. Do not expose the device to sunlight and do not use it in close proximity to heat-generating devices (heaters, radiators etc.). Plastic parts may deform, which may affect the operation of the device or cause it to break down completely.

• BATTERY
  Avoid exposing the battery to very high/low temperatures (0ºC – 45 ºC / 32ºF – 113ºF). Extreme temperatures may influence capacity and battery life. Avoid contact with liquids and metal objects as it may cause partial or complete battery damage. The battery should be used according to its purpose. Do not destroy, impair or throw the battery into flames – it might be dangerous and may cause fire. Worn-out or impaired battery should be placed in a dedicated container. Excessive charging the battery can cause damage. Therefore do not charge longer than necessary. The battery in the device is not replaceable.

• CONTRAINDICATIONS
  Do not use the massager without a doctor’s approval in the following cases: pregnancy, cancer, cardiac pacemaker, metal bone fusions, recent surgery, osteoporosis, epilepsy, thrombosis, migraine, hypertension, kidney stones, varicose veins, disc herniation, spondylolisthesis, spondylosis, spondylolysis, recent joint replacement, acute inflammation, open wounds.
  Do not massage face muscles, backbone (directly) or bone If you experience pain or discomfort during the massage, stop the massage immediately.

Technical Specification

Technical data

Vibrating massager

Model| TS-4312
Rotation| Up to 3000 rpm
Max. noise level| 50 dB
Power supply| 5 V ⎓ 2A
Built-in battery| Li-ion 7,4 V ⎓ 1800 mAh, 13,32 Wh
Material| ABS
Additional| Four replaceable tips, USB-C cable, moving head

Package content

• Massager
• Interchangeable tips (4 pcs)
• USB-C cable
• User manual
  If any of the above items is missing or damaged, please contact your dealer.
  We advise to keep the container in case of any complaints.

Device construction

1. Moving head
2. Grip
3. Signal diodes
4. Multifunctional button
5. Charging socket
6. LED status

Interchangeable massage tips

The use of the equipment

Battery charging

• The battery should be fully charged before the first use of product. Several charging and discharging cycles may be necessary to achieve full battery capacity.
• Avoid excessive battery discharge. This can damage the battery or shorten its service life. A low battery charge is indicated by the status LED (6) flashing quickly in red, blue and violet.
• The device can heat up during charging. It is a regular occurrence and should not affect the stability or performance of the device. Do not leave the device to be charged unattended as this may result in fire, damage to the device or its surroundings etc.
  To charge your device, connect the USB-C plug of the supplied cable to the charging socket (5) on your device. Connect the other end of the cable to a powered USB adapter or, for example, a socket on your computer, a powerbank, etc., whose output guarantees a power supply of 5 V ⎓ 2 A or higher. When charging starts, the LED diode lights up red. When the battery is charged, the LED changes colour into green. Once charged disconnect USB from the device and from the power source.
  The device cannot be used during charging.

Turning the device on, off and operating it

• For safety reasons the massager automatically switches off after fifteen minutes of continuous operation. Turn the device on to use it again.
• Avoid massaging one area for a long time during the massage. Gently move the device while massaging.
• Press and hold the multifunction button (4) for about 3 seconds to switch off the device.
• The massager will turn on at the lowest massage intensity. Subsequent short presses of the multifunction button will change the massage intensity level to a higher one.
• When the fourth massage intensity level is reached, another press of the multifunction button will switch to the lowest intensity.
• The current massage intensity level is indicated by four LEDs (3) – the number of lit LEDs corresponds to the current massage intensity.
• Pressing and holding the multifunction button for approx. three seconds during operation will switch off the device.

Replacement of massage tips and adjustment of the moving head

Massage tips should only be changed and the moving head adjusted when the device is switched off.

To remove the tip, grasp the massager body with one hand and the neck of the massager tip with the other. Pull the two pieces in opposite directions while rotating the tip around its axis.
The tip is assembled by pressing its neck into the hole located in the moving head of the massager body. After installation, make sure that the tip is correctly positioned.

The moving head (1) is 90º adjustable. This allows the unit to be conveniently configured for better user comfort. To change the position of the moving head, grasp the massager body handle (2) with one hand and the moving head with the other. Then move the moving head as shown in the illustration below.

Troubleshooting

If you have problems with the unit, please refer to the following tips.

The device does not switch on| Check that the battery is charged.

Check that the cables, plugs and sockets supplying power to the unit are not damaged.

---|---
After switching on, the head does not vibrate| Check if the head is not blocked somehow.

Perhaps there has been a damage to the engine. Contact the manufacturer’s service department.

If the problem persists, contact the manufacturer’s service department.

Maintenance of the device

To extend the service life of the device:

• For cleaning use only a dry cloth. Never use any agent with a high concentration of acids, alkalis or abrasives.

• Keep the device and its accessories out of reach of children.

• Avoid very high temperatures, for it can shorten the life of electric and electronic components, melt the plastic parts and destroy the battery.
  The packaging of the device can be recycled in accordance with local regulations.

• Symbol for corrugated cardboard (packaging material).

• The packaging elements should be disposed of in appropriate containers.

• The marking of the container into which the box – paper should be discarded.

Correct disposal of used equipment and battery

The device is marked with a crossed-out garbage bin, in accordance with the European Directive 2012/19/EU on used electrical and electronic Equipment (Waste Electrical and Electronic equipment – WEEE). Products marked with this symbol should not be disposed of or dumped with other household waste after a period of use. The user is obliged to get rid of used electrical and electronic equipment by delivering it to designated recycling points in which dangerous waste are being recycled. Collecting this type of waste in designated locations, and the actual process of their recovery contribute to the protection of natural resources. Proper disposal of used electrical and electronic equipment is beneficial to human health and environment. To obtain information on where and how to dispose of used electrical and electronic equipment in an environmentally friendly manner user should contact their local government office, the waste collection point, or point of sale, where the equipment was purchased.

According to the EU directive 2006/66/EC with changes contained in EU directive 2013/56/UE on the disposal of batteries, this product is marked with crossed-out garbage bin symbol. The symbol indicates that the batteries used in this product should not be disposed with regular household waste, but treated according to the legal directives and local regulations. It is not allowed to dispose of accumulators with unsorted municipal waste. Users of batteries and accumulators must use the available collection points of these items, which allows them to return, recycle and disposal. Within the EU, the collection and recycling of batteries and accumulators is subject to separate procedures. To learn more about existing procedures of recycling of batteries and accumulators please contact your local office or an institution for waste disposal or landfill.

The use of the manual

Without prior written consent of the manufacturer, no part of this manual may be photocopied, reproduced, translated or transmitted in any form or by any means, electronic or mechanical, including photocopying, recording or storing in any systems of storing and sharing information.
All brand names and product names are trademarks or registered trademarks of their respective companies.

Warranty and service

The product is covered by a 3-year warranty, counting from the date of sale of the product. If you need to make use of a warranty claim, please contact the manufacturer’s helpline or point of sale. The product returned for warranty claim should be complete and in its original packaging.

Declaration of conformity with European Union Directives

mPTech Sp. z o.o. hereby declares that the product complies with all relevant provisions of the so called the ‘New Approach’ Directive of the European Union.

References

• myPhone: making mobile technology accessible

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>