Veratron GO GPS GNSS Receiver Instruction Manual

June 9, 2024
veratron

Veratron GO GPS GNSS Receiver

Veratron GO GPS GNSS Receiver-FIG1

PRODUCT OVERVIEW

Veratron GO GPS GNSS Receiver-FIG2

Before assembly

NOTICE: short circuit. Cable burning, battery explosion. Remove the ignition key and detach the battery negative pole terminal.
NOTICE: NMEA 2000 network overload. Burnt cables. Check current absorption on devices connected to the NMEA 2000 network and dimension the power cable accordingly.

Box contents

  • Veratron GO GPS
  • These installation instructions
    Note: for more information on available accessories, refer to the accessory catalog or visit www.veratron.com.

Technical specifications

Material Acrylonitrile Styrene Acrylate (ASA)
Connector NMEA 2000® Micro-C 5-pin M12 connector (male, product side)
IP Protection Class IPX7 according to IEC60529 (or EN 60529)
Supply Voltage 12V (powered from NMEA 2000®)
Time To First Fix (TTFF) Cold Start -30 sec
Position accuracy 2.5 m with good sky view

GNSS

augmentation

| SBAS-WAAS / EGNOS

/ MSAS / GAGAN

Reception channels| 72
Update rate| 10 Hz

Micro-C 5-pin M12 connector

(male, product side)
Note: use according to NMEA 2000 protocol.

  1. Shield
  2. NET-S (V+)
  3. NET-C (V-)
  4. NET-H (CAN H)
  5. NET-L (CAN L)

NMEA 2000 Data

PGN 126992 System Time
PGN 129025 Position, Rapid Update
PGN 129026 COG & SOG, Rapid Update
PGN 129029 GNSS Position Data
PGN 129539 GNSS DOPs
PGN 129540 GNSS Satellites in View

Install the Veratron GO GPS

Where to install

Veratron GO GPS GNSS Receiver-FIG3

Veratron GO GPS GNSS Receiver-FIG4

Industriestrasse 18, 9464 Rüthi,
Switzerland
www.veratron.com
info@veratron.com

Content subject to change

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals