els pet Self Cleaning Cat Litter Box User Manual

ELSPET SMART
CAT LITTER BOX

User manual

Thank you for using elspet products. For your safety and better use of this product, please read this user manual carefully. Keep this manual properly for future use.

Product specification

Important note

• Pull the pedal out before use
• Adjust the time according to the actual situation
• Do not push the door
• Timely sand replenishment
• Don’t use long strips of tofu Kitty litter
• Do not expose yourself to ultraviolet rays for a long time
• Dispose of litter boxes in time
• Clean pedals, garbage boxes, inner doors, claws and sand basins regularly
• Use the 12V4A adapter. Do not use other adapters
• If you need to move or transport, please press shutdown and then power off

Preparation steps before use

(Mixed or bentonite cat litter less than 5mm in length is recommended)

Bind Elspet smart APP

Software Installation method:

1. Scan the QR code on the right to download and install
2. Apple App Store search elspe
3. Google App Store search for Elspe

https://smartapp.tuya.com/elspetsmart

APP Connection Steps

APP sand indicator and reset

APP Device Sharing

Detailed explanation of assembly method

Disassembling cleaning steps

Product Function Introduction

1. Button system

Dutton (1 : power switch: press to start: Long press shutdown; When the machine is on. press open manual feces shoveling
Button (2: Quiet sleep switch: the indicator light means open fin standby slate at night), to the day automatic reply
Button) ilamp mg switch: open can be used for lighting, off in the closed state. specific instructions see the next page
Button 4 : Mode button: On indicates that the switch is started Press once in the pwrciren state to increase the cut litter gathering time from 10 minutes to 20 minutes Press once in the oft state to enter the cleaning mode

2. Time adjustment
   
   Long press the button, the hour hand flashes, and each press increases one hour. Long press the (2) button, the minute hand flashes, and each press increases one minute.

Indicator ring diagram

Blue light:
Steady on: Standby Blinking slowly: Sterilization and deodorization Green light: Steady on: Ready mode Flashing: Start shoveling feces
Red light:
Steady on: pedal move Slow flash: Sand basin sticking bottom (need to clean by oneself) Flash: The machine is faulty

Ultraviolet sterilization instructions

After clearing the clumps, ultraviolet light turns on Time: 20 minutes (APP adjustable time) It automatically stops when the pet enters the cabin

Induction system

When the electric door is closing, pet entry will immediately stop closing and re-open.

Common faults/solutions

1. If the cat enters the interior when the door is about to close, the fuselage will detect the cat and immediately stop the door and reopen it 10 seconds after the cat leaves and then operate again to complete cleaning.
2. When the cat litter is found stuck to the bottom, the rake will stop working and sound the alarm, return to the original position and enter the standby state. (The red light ring of the stand-alone version is on, and the blue light ring of the wifi version is on), it can be used normally after the next cleaning.
3.  The reason for displaying the foreign body card may be the door close switch shrapnel falling/door deformation/door motor damage/cat litter stick-ing to the bottom/too much cat litter/rake deformation, etc., which will prompt the red or blue light flashing.
4. If the garbage bag near the sand bin is not covered properly, the rake will be stuck. Please check and adjust it in time

This device complies with Industry Canada licence-exempt RSS standard( s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.”

FCC Warning

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause un-desired operation.
Any Changes or modifications not expressly approved by the party responsi-ble for compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. How- ever, there is no guarantee that interference will not occur in a particular in-stallation. If this equipment does cause harmful interference to radio or televi-sion reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>