unitech TB170 Rugged Tablet User Manual
- June 9, 2024
- unitech
Table of Contents
Tablet
– TB170-
Product Manual
TB170 Rugged Tablet
Date | Change Description | Version |
---|---|---|
20220518 | First Published Version | V1.0 |
20220715 | Add RoHS Statement on p.11 | V1.1 |
Foreword
Thank you for purchasing a Unitech product.
This manual will introduce how to set up, operate and use this product,
including basic settings and application program introduction.
Without the written permission of the manufacturer, it may not be reproduced
in any form, by electronic or mechanical means (such as photocopying,
recording or information storage and retrieval systems) reproduce or use any
part of this publication. The contents of this manual are subject to change
subject to change without notice.
Regulatory Compliance Statements
FCC Warning Statement
This device has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference with radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
with radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment and receiver.
–Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.
- This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
- This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. To maintain compliance with FCC RF exposure requirements, avoid direct contact to the transmitting antenna during transmitting.
- Any changes or modifications (including the antennas) made to this device that are not expressly approved by the manufacturer may void the user’s authority to operate the equipment.
FCC Label Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
RF Radiation Exposure Statement
For body contact during operation, this device has been tested and meets FCC
RF exposure guidelines when used with an accessory that contains no metal and
that positions the handset a minimum of 1.0 cm from the body. Use of other
accessories may not ensure compliance with FCC RF exposure guidelines.
European Conformity Statement
Unitech Electronics co., Ltd herewith declares that the Unitech product is in
compliance with the essential requirements and all other provisions of the RED
2014/53/EU directive.
The declaration of conformity is available for download at :
https://portal.Unitech.eu/public/Safetyregulatorystatement
CE RF Exposure Compliance
For body-worn operation, this device has been tested and meets the ICNIRP
guidelines and the European Standard EN 62209-2, for use with dedicated
accessories, SAR is measured with this device at a separation of 0.5 cm to the
body, while transmitting at the highest certified output power level in all
frequency bands of this device. Use of other accessories which contain metals
may not ensure compliance with ICNIRP exposure guidelines.
CE Mark Warning
RoHS Statement
This device conforms to RoHS (Restriction Of Hazardous Substances) European
Union regulations that set maximum concentration limits on hazardous materials
used in electrical and electronic equipment.
Waste electrical and electronic equipment (WEEE)
Unitech has set up a policy and process to meet the 2012/19/EU concerning
electronic waste disposal.
For more detailed information of the electronic waste disposal of the products
you have purchased from Unitech directly or via Unitech’s resellers, you shall
either contact your local supplier or visit us at :
https://portal.Unitech.eu/public/WEEE
Taiwan NCC Warning Statement
NCC warnings
The low-power radio frequency equipment that has obtained the verification
certificate shall not be changed by the company, trade name or user without
approval.
Change the frequency, increase the power or change the characteristics and
functions of the original design.
The use of low-power radio frequency equipment must not affect flight safety
and interfere with legal communications; interference is found
When it occurs, it should be stopped immediately, and it can only be used when
it improves to no interference.
The aforementioned legal communication refers to radio communication operated
in accordance with the provisions of the Telecommunications Management Act.
Low power RF equipment must endure
Interference with legal communication or industrial, scientific and medical
radio wave radiation electrical equipment.
SAR standard value W/KG, the measured value of the sent product is: (W/KG)
Precautions:
- Excessive use may damage eyesight.
- Please rest for 10 minutes after using for 30 minutes; children under 2 years old do not look at the screen, and children over 2 years old do not watch the screen for more than 1 hour.
- To reduce the influence of electromagnetic waves, please use it properly.
Laser Information
The Unitech product is certified in the U.S. to conform to the requirements of
DHHS/CDRH 21CFR Subchapter J and to the requirements of IEC 60825-1.
Class II and Class 2 products are not considered to be hazardous. The Unitech
product contains internally a Visible Laser Diode (VLD) whose emissions do not
exceed the maximum limits as set forth in the above regulations. The scanner
is designed so that there is no human access to harmful laser light during
normal operation, user maintenance or prescribed service operations.
The laser safety warning label required by the DHHS/IEC for the Unitech
product’s optional laser scanner module is located on the memory compartment
cover, on the back of the unit.
- Laser information only applies to the products with laser components.
CAUTION! Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous laser light. Use of optical instruments with the scanner, including binoculars, microscopes, and magnifying glasses, with will increase eye damage.
This does not include eyeglasses worn by the user.
LED Information
The Unitech product contains LED indicator(s) or LED ring whose luminance is
not harmful to human eyes during normal operation, user maintenance or
prescribed service operations.
*LED information only applies to the products with LED components.
Battery Notice
-
To guarantee optimal performance, it is recommended that rechargeable batteries be replaced every year, or after 500 charging cycles are completed. It is normal for the battery to balloon or expand after one year or 500 cycles. Although it does not cause damage, it cannot be used again and must be disposed of according to the location’s safe battery disposal procedures.
-
If a battery performance decreases more than 20%, the battery is at the end of its life cycle. Stop use and ensure the battery is disposed of properly.
-
The length of time that a battery lasts depends on the battery type and how the device is used. Conserve the battery life by doing the following:
Avoid fully uncharging the battery because this places additional strain on it. Several partial uncharges with frequent charges are better than a fully uncharged battery. Charging a partially charged battery does not cause harm to the unit.
Keep the battery cool. Avoid hot vehicles. For prolonged storage, keep the battery at a 40% charge level.
Do not leave the battery uncharged and unused for an extended period of time, the battery will wear out and the longevity of the battery will be at least half of one with frequent charges. -
Protect battery life by not over or under charging the battery.
-
Please do not leave battery unused for long time without charging it.
Despite Unitech’s safety precautions, the battery pack may begin to change shape. If so, stop using it immediately. Please check to see if you are using a proper power adapter to charge the battery or contact your service provider for service. -
If you cannot charge the battery after it has been idle for an extended period of time and it begins to heat up, please do not try to charge it. It may not be functional anymore.
-
Please only use the original battery from Unitech. Using a third party battery can damage our products. Please note that when such damage occurs, it is not covered by Unitech’s warranty policy.
CAUTION!
- RISK OF EXPLOSION IF BATTERY IS REPLACED INCORRECTLY.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
Battery charge notice
It is important to consider temperature when the battery pack is charging.
Charging is most efficient at normal room temperature or in a slightly cooler
environment. It is essential that batteries are charged within the stated
range of 0°C to 40°C. Charging batteries outside of the specified range could
damage the batteries and shorten their life cycle.
CAUTION! Do not charge batteries at a temperature lower than 0°C. This
will make the batteries unstable and dangerous. Please use a battery
temperature detecting device for a charger to ensure a safe charging
temperature range.
CAUTION! To ensure the unit working properly, please keep all connectors
away from the contaminants staying inside of them such as dust, grease, mud,
and water. The negligence may cause the unit with no communication, short
circuited, overheated and so on.
CAUTION! If the connector is damaged, please ensure the connector is
being fully repaired before use the unit to avoid causing short circuited.
Storage and safety notice
Although charged batteries may be left unused for several months, their
capacity may be depleted due to build up of internal resistance. If this
happens, they will require recharging prior to use. Batteries may be stored at
temperatures between -20°C to 60°C, however they may deplete more rapidly at
higher temperatures. It is recommended to store batteries at room temperature.
- The message above only applies to the usage of the removable batteries.
For the products with non-removable batteries / without batteries, please refer to the specification of each product.
Product Operation and Storage Notice
The Unitech product has applicable operation and storage temperature conditions. Please follow the limitation of suggested temperature conditions to avoid failure, damage or malfunction.
*For applicable temperature conditions, please refer to the specification of each product.
Adapter Notice
- Please do not leave the power adapter in the socket when it is not connected to your Unitech product for charging.
- Please remove the power adapter when the battery is fully recharged.
- The bundled power adapter that comes with your Unitech product is not meant to be used outdoors. An adapter exposed to water or rain, or a very humid environment can cause damage to both the adapter and the product.
- Please only use the bundled power adapter or same specification of adapter to charge your Unitech product. Using the wrong power adapter can damage your Unitech product.
- The message above only applies to the product connected to the adapter.
For the products without using the adapters, please refer to the specification of each product.
Hearing Damage Warning
To prevent possible hearing damage, do not listen at high volume levels for long periods.
Worldwide Support
Unitech’s professional support team is available to quickly answer questions
or assist with technical-related issues. Should an equipment problem occur,
please contact the nearest Unitech regional service representative.
For complete contact information please visit the Web sites listed below:
Taipei, Taiwan – Headquarters
Tel: +886-2-89121122
E-mail: info@hq.ute.com
Address: 5F, No. 136, Lane 235, Baoqiao Road, Xindian
District, New Taipei City 231, Taiwan (R.O.C.)
Website: http://www.ute.com| Europe
Tel: +31-13-4609292
E-mail: info@eu.ute.com
Address: Kapitein Hatterasstraat 19, 5015 BB,
Tilburg, the Netherlands
Website: http://eu.ute.com
---|---
China
Tel: +86-59-2310-9966
E-mail: info@cn.ute.com
Address: Room401C, 4F, RIHUA International Mansion,
Xinfeng 3nd Road, Huoju Hi-tech District,
Xiamen, Fujan , China
Website: http://cn.ute.com| Japan
Tel: +81-3-35232766
E-mail: info@jp.ute.com
Address: Kayabacho Nagaoka Building 8F.,1-5-19
Shinkawa, Chuo-Ku,
Tokyo, 104-0033, Japan
Website: http://jp.ute.com
Asia & Pacific / Middle East
Tel: +886-2-27911556
E-mail: info@apac.ute.com
info@india.ute.com
info@mideast.ute.com
Address: 4F., No. 236, ShinHu 2nd Rd.,
NeiHu Chiu, 114, Taipei,Taiwan
Website: http://apac.ute.com/ http://mideast.ute.com| Latin America
Tel: +52-55-5171-0528
E-mail: info@latin.ute.com
Address: 17171 Park Row, Suite 210 Houston, TX 77084USA (Rep.)
Website: http://latin.ute.com
|
North America
Tel: +1-714-8916400
E-mail: info@us.ute.com /
info@can.ute.com
Address: 6182 Katella Ave, Cypress, CA 90630, USA
Website: http://us.ute.com| Please scan QR Code to visit us :
Warranty Policy
The following items covered under the Unitech Limited Warranty are free from
defects during normal use:
The warranty period is varied from each country. Please consult with your
supplier or Unitech local office for actual length of warranty period to your
purchased product.
Warranty becomes void if equipment is modified, improperly installed or used,
damaged by accident or neglect, or if any parts are improperly installed or
replaced by the user.
© 2022 Unitech Electronics Co., Ltd. All rights reserved.
Unitech is a registered trademark of Unitech Electronics Co., Ltd.
All product and company names are trademarks, service marks, or registered
trademarks of their respective owners
References
- Unitech Electronics
- Unitech Electronics
- 精瑞电脑 unitech
- Unitech Europe (EMEA) | Your Brilliant AIDC Solution Provider
- Unitech Global | Your Brilliant AIDC Solution Provider
- Unitech Global | Your Brilliant AIDC Solution Provider
- Unitech Global | Your Brilliant AIDC Solution Provider
- Unitech Global | Your Brilliant AIDC Solution Provider
- dtsc.ca.gov/hazardouswaste/
- Unitech Global | Your Brilliant AIDC Solution Provider
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>