91P900 2010-19 Flex MRT Sport Touring Axle Back Instruction Manual
- June 9, 2024
- MRT
Table of Contents
2010-19 Flex MRT Sport Touring Axle Back
Part No. 91P900
Installation Instructions
91P900 2010-19 Flex MRT Sport Touring Axle Back
Tools Required
Hack Saw or Saw All
15mm Wrench/Socket
Materials Included
Qty (1) – Left (Driver Side) Axle Back Pipe
Qty (1) – Right (Passenger Side) Axle Back Pipe
Qty (2) – 2 ¼” Exhaust Band Clamps
Instructions Sheet
Warranty Information
IMPORTANT – The warranty on this product is VOID if the product is not properly installed, or has been modified or altered in any way. If you believe that modification will be required to fit an MRT Exhaust System on your vehicle, please contact MRT for assistance BEFORE making any modifications to the system.
Instructions
- Place a straight edge alongside the length of stock muffler until it meets straight portion of exhaust tubing. Draw cut line, cut on line.
- Repeat step on opposite side
- Remove stock mufflers
- Remove burr or rough metal from edge of the stock exhaust tube
- Slide band clamp on to tail pipe
- Slide mufflers over existing stock tubing, insert hanger rod into isolator
- Align tip to rear fascia opening
- Position clamp to the edge of MRT exhaust so that the clamp will overlap stock exhaust tubing approximately 1/8”.
- Tighten clamp while maintaining tip alignment.
NOTE: Adjustment of tip can be made by sliding the axle back in/out and
rotating at clamp joint.
MRT appreciates your business; please feel free to contact us at any point
with questions or concerns at
734-455-5807 or via email at Sales
@MRT-Direct.com
ShopMRT.COM
#91P900
Documents / Resources
| MRT
91P900 2010-19 Flex MRT Sport Touring Axle
Back
[pdf] Instruction Manual
91P900 2010-19 Flex MRT Sport Touring Axle Back, 91P900, 2010-19 Flex MRT
Sport Touring Axle Back, Flex MRT Sport Touring Axle Back, Sport Touring Axle
Back, Touring Axle Back, Axle Back
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>