gorenje MG1802SJW Meat Grinder Instruction Manual

: June 4, 2024
: Gorenje

Table of Contents

INSTRUCTION MANUAL
Important
Safety system
Environment
Guarantee & service
Documents / Resources

Meat grinder MG1802SJW
Instruction manual
gorenje MG1802SJW Meat Grinder - fig

INSTRUCTION MANUAL

1. Motor unit	6. Sausage horn
2. On-OFF button / Reverse	7. Grinding disc
3. Release button	8. Separator
4. Cutter housing	9. Cutters
5. Feeding tray	10. Slow juicer

Important

Read these instructions for use carefully before using the appliance and save them for future reference.

Noise level: Lc <85 dB(A)
This appliance can be used by children aged 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and maintenance shall not be made by children unless they are older than 8 and supervised.
Check if the voltage indicated on the appliance corresponds to the local mains voltage before you connect the appliance.
In order to avoid a hazardous situation, this appliance must never be connected to a timer switch.
Do not use the appliance if the mains cord, the plug or other parts are damaged.
If the mains cord is damaged, it must be replaced by Gorenje, a service center authorized by Gorenje or similarly qualified persons in order to avoid a hazard.
Keep the appliance out of the reach of children.
Never let the appliance run unattended.
Never exceed the maximum operating time of 10 minutes at all applications.
Always switch the appliance off by pressing the on/off button.
Switch the appliance off and unplug it before detaching any accessory.
Never immerse the motor unit in water or any other liquid, nor rinse it under the tap.
Never use your fingers or an object (e.g. a spatula) to push ingredients into the cutter housing while the appliance is running. Only the pusher is to be used for this purpose.
Be very careful when handling the cutter unit, especially when removing it from the worm shaft and during cleaning. The cutting edges are very sharp!
Never use any accessories or parts from other manufacturers or that have not been specifically advised by Gorenje, d.d.. Your guarantee will become invalid if such
accessories or parts have been used.
Thoroughly clean the parts that will come into contact with food before you use the appliance for the first time.
Do not clean the metal parts in the dishwasher, as dishwasher detergents will cause these parts to darken or oxidize. See the Cleaning section for instructions on how to
clean the various parts.
This appliance is meant for household use only.
Never connect this appliance to an external timer switch or remote control system in order to avoid a hazardous situation.

This appliance is marked according to the European directive 2012/19/EU on Waste Electrical and Electronic Equipment (WEEE). This guideline is the frame of a European-wide validity of return and recycling on Waste Electrical and Electronic Equipment.

Safety system

This appliance is equipped with a nonresettable, current-sensitive glass fuse that cuts off the power supply in case of motor failure to prevent overheating of the appliance. This system will automatically cut off the power supply to the appliance in case of overheating. If your appliance suddenly stops running:

Pull the mains plug out of the socket.
Let the appliance cool down for 60 minutes
Put the mains plug in the socket.
Press the switch button to turn off the appliance.
Press the circuit breaker button at the bottom of the appliance to turn on the appliance.

Please contact your dealer of an authorized service center if the thermostat system is activated too often.
Cleaning – tips and warnings
− Remove any meat left in the cutter housing by passing pieces of bread through it.
− Always switch off and unplug the appliance before removing accessories or cleaning the motor unit.
− Remove the pusher and the feeding tray.
− Unscrew the screw ring and remove the grinding disc, the cutter unit and the worm shaft.
− Remove the cutter housing by pressing the release button and by turning the cutter housing to the right (see the Disassembly section,
− The cutter unit and grinding discs should be lightly brushed with fat or oil to prevent rusting.
− Do not clean the metal parts in the dishwasher, as dishwasher detergents will cause these parts to darken or oxidize.

Environment

Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. By doing this, you help to preserve the environment.

Guarantee & service

If you need information or if you have a problem, please contact the Gorenje Customer Care Centre in your country (you find its phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your country, go to your local Gorenje dealer or contact the Service department of Gorenje domestic appliances.

For personal use only!
GORENJE WISHES YOU A LOT OF PLEASURE WHEN USING YOUR APPLIANCE
We reserve the right to any modifications!