JBL 109XD5B Stage XD Indoor-Outdoor Speakers Owner’s Manual
- June 9, 2024
- JBL
Table of Contents
JBL 109XD5B Stage XD Indoor-Outdoor Speakers
Overview
This Quick Start Guide contains basic information on the Stage XD Indoor/Outdoor loudspeakers, important pre-installation steps, and important safety warnings about the installation of this product. Read through this document in its entirety before proceeding with the installation.
After reading this document visit the product page on the JBL Specialty Audio website for complete installation instructions for these products.
Supported Products
This document supports the following products.
- Stage XD-5: 2-way 5.25 inch All Weather Loudspeaker
- Stage XD-6: 2-way 6.5 inches All Weather Loudspeaker
Box Contents
- 2x Stage XD-5 or XD-6 Loudspeakers
- 2x Zero Bezel Grilles
- 4x Rubber Feet
- 1x Grille Removal Tool
- 2x Wall Installation Kit (Mounting Bracket)
- 1x Quick Start Guide (This Document)
IMPORTANT!
HARMAN International assumes no responsibility for improper installation of
hardware, any personal injuries, or product damages resulting from improper
installation or a fallen loudspeaker. Read through this document and other
documents associated with this product in their entirety and heed all warnings
before proceeding with the installation of these product(s).
IMPORTANT! Installation Precautions
Due to the nature of this product, there are several precautions to follow
before installation can begin.
- Ensure that all wiring running inside of walls and ceiling meets or exceeds local fire codes for hidden wiring.
- Determine wire lengths and select the proper gauge speaker wire to use based on the table under Wire Gauge by Distance.
- Do NOT connect the speakers to an amplifier rated above the recommended amplifier power. Overdriving the speaker can cause an overheating condition increasing the risk of injury.
- Do NOT connect the amplifier end of the wire until all speakers are wired and installed.
Wire Gauge by Distance
| Distance/Length | Wire Gauge |
|---|---|
| < 50ft (15m) | 16AWG |
| 50ft (15m) ~ 100ft (30m) | 12AWG |
| >100ft (30m) | 10AWG |
Wall Installation
The Stage XD speaker can be installed on a wall using the included Wall Installation Hardware. Follow the instructions carefully to ensure proper installation.
- Install lock nut [A] onto threaded knuckle [C] away from the end.
- Slide lock ring [B] over threaded knuckle [C].
- Secure lock nut [A] onto the speaker.
- Locate the mounting position on the wall leaving enough space for the speaker to clear the ceiling and/or other obstacles. Secure the knuckle joint [D] to the wall with the included security cable [E] on one of the bottom screws.
- Install the knuckle [C] into the joint [D] and secure the lock ring [B].
Adjusting Angle and/or Orientation
Once the speakers are installed on the wall they can be adjusted for angle and orientation. Simply loosen the lock ring slightly and move the speaker within the mount into the desired orientation. Note that for horizontal orientation the logo can be rotated.
Tabletop Installation
While the common use is to install Stage XD speakers onto a wall, they can also be used on a table/desktop. To use on a flat surface, install the included rubber feet onto the bottom of each speaker at the rear outer corners.
Connecting Speakers
- Ensure that the appropriate wire gauge has been run based on the Wire Gauge by Distance chart.
- Ensure that wires are marked for polarity to ensure speakers are not connected out of phase.
- Connect positive wires to the (+) terminal and negative feed wire to the (-) terminals.
- Continue connecting until all speakers are connected.
Specifications
Stage XD-5 Stage XD-6
**** High-Frequency Transducer| 1″ (25mm) Aluminum dome with High- Definition Imaging (HDI™) waveguide| 1″ (25mm)
Aluminum dome with High-Definition Imaging (HDI™) waveguide
Low-Frequency Transducer| 5.25″ (130mm)
Polycellulose cone woofer
| 6.5″ (165mm)
Polycellulose cone woofer
Nominal Impedance| 6ohms| 6ohms
Sensitivity (2.83V@1m)| 86dB| 88dB
Recommended Amplifier Power| 20-100W RMS| 20-100W RMS
Frequency Response (-6dB On-Axis)| 75Hz-25kHz| 55Hz-25kHz
Crossover Frequency| 2500kHz| 2500kHz
Dimensions HxWxD
| 9.84in (249.9mm) x 7.17in (182.1mm) x 6.37in (161.8mm)| 11.77in (299mm) x
8.73in (221.8mm) x 7.64in (194.1mm)
Wall Mount Length| H: 2.8 (71mm)| H: 2.8 (71mm)
Harman International Industries, Incorporated.
8500 Balboa Blvd, Northridge CA 91329 United States.
European Representative:
Harman International Industries, Incorporated.
EMEA Liaison Office, Danzigerkade 16G, 1013 AP Amsterdam, The Netherlands.
UK Business Address:
Ground Floor, Westside 2, London Road, Apsley, Hemel Hempstead, Hertfordshire,
HP3 9TD, United Kingdom. © 2022 Harman International Industries, Incorporated.
All Rights Reserved.
JBL is a trademark of Harman International Industries, Incorporated registered in the United States and other countries. Features, Specifications, and Appearances are subject to change without notice.
Stage XD Indoor/Outdoor Speakers Quick Start Guide | Rev 1.4 20221117 | Part No. 950-0608-001.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>