TQB PROTRJA20T Truck Jack Air/Actuated Bleed Instructions
- June 9, 2024
- TQB
Table of Contents
PROTRJA20T Truck Jack Air/Actuated
Bleed Instructions
Truck Jack Air/Actuated Bleed Instructions
Product Code: PROTRAJ20T
PROTRJA20T Truck Jack Air/Actuated Bleed
The usual fault symptoms of a TopPro PROTRAJ20T Air/Hydraulic Truck Jack with
air in the system are as follows.
– Air Motor Pump runs but no movement in the Lift ram.
– Lift Ram will only partially extend then air motor runs on.
BLEED INSTRUCTIONS: Air Motor Pump
- With a leveraging tool Remove the 3 return springs from the Spring Saddle and remove the Spring Saddle to reveal the Filler Bung.
- Remove the filler bung and if required, refill with ISO68 Grade Hydraulic Oil until the oil is lapping the bottom of the filler hole. Replace the Filler Bung, Spring Saddle & Return Springs.
- Connect the air supply line to the Raise/Lower Control valve at the top of the handle assembly.
- Turn the Raise/Lower control knob to the raise position and hold until the ram reaches full extension.
- Turn the Raise/Lower control knob to the lowering position and hold until the ram is fully retracted.
- Repeat steps 1 to 2 checking the oil level and topping up if required.
- Repeat steps 3 to 5 checking oil level at step 5 until the rams extend smoothly to full extension.
At this point the Air Motor Pump and Lift Ram should be free of air and the Jack ready for operation. If the jack continues to show the symptoms as above repeat steps 1 to 7 or please refer to a Qualified Hydraulic Technician.
*These TopPro Truck Jacks use ISO68 Grade Hydraulic Oil for the correct operation and compatibility with the seals used in their construction.
M W Nadler
www.tqbbrands.com.au
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>