TAP BC-R Clarinet and Saxophone Sensor Instructions
- June 9, 2024
- TAP
Table of Contents
Clarinet and Saxophone Sensor
Instructions
BC-R
FEATURES – INSTRUCTION
TAP clarinet (and saxophone) sensor (mic) is handmade pre-adjusted by
extremely high accuracy apparatus and highly professional long-term
experienced sensor makers. It is made to be noise-free and able to match all
Amps and consoles.
Perfectly balanced, satisfying even the most demanding customer with a natural
undistorted clarinet sound. Our company makes this sensor with an internal
build-in volume control and three positions lever switch. You can easily and
quickly customize the sound as to the volume.
The sensor has a big dynamic middle frequency range.
The mic does not pick up the “clicking” noise, produced by the instrument’s
key due to its internal noise isolation. Also the sensor has humidity
isolation.
The installation of the sensor is done by screwing the device on the barrel
section of the clarinet. Don’t forget to put on the rubber ring(s) before
screwing the sensor to avoid air leak. Direct output from Rica- jack using a
cable.
INSTALLATION
* Drill hole 5.2mm on the barrel. Make the threading with {M6} hand tap
cutting tool. Finish the edges of the hole with rasp. Screw the Adapter into
the threading. Put the rubber ring on the Mic-sensor. Screw with care the Mic-
sensor into the adaptor. Twist the cable on the barrel for protection.
Maintenance: Always keep the sensor on the top direct on your eyes. Unscrew
the sensor and wipe with soft paper. Never miss to unscrew sensor from the
clarinet when not in use.
Warning** : Never use hard tools or items on sensor surface. The
installation recommended to be done by a technician.