Lucci LEDlux 240312 Ceiling Light Instruction Manual

: June 9, 2024
: LUCCi LEDlux

Table of Contents

Lucci LEDlux 240312 Ceiling Light
Warranty
Installation requirements
Installation directions
Safety tips
Specifications
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Lucci LEDlux 240312 Ceiling Light

Thank you for purchasing this quality Lucci product. To ensure correct function and safety, please read and follow all instructions carefully before using the product. Please keep instructions for future reference.

Warranty

This light fitting is covered by a 3 year warranty. Please retain proof of purchase and evidence of installation by a licensed electrician.
Warranty will be void if there is any damage due to improper usage or modification to the fitting.

Installation requirements

Must be installed by a licensed electrician.
All wiring and installation of the light fitting must adhere to local and national wiring rules. eg. AS/NZS 3000:2007/Amendment 2:2012 Electrical installations.
Do not exceed the maximum wattage rating.
Select a suitable location for installation;
- This product is suitable for indoor and outdoor use.
- The mounting point must support 2 times the weight of the fitting.
- This fitting must not be mounted on a surface which can be subject to vibrations.
- This fitting is protected against water penetration to IP44 standards, which is splashing in every direction. Take note of the directional label on the fitting before installation.
Take care not to pull any electrical wires during unpacking as this may damage the connection.
Lay out all the components on a smooth surface and make sure there are no components missing before assembling.
Check whether the fitting has been damaged during transport. Do not operate/install any product which appears damaged in any way. Return the complete product to the place of purchase for inspection, repair or replacement.
Ensure power to the circuit you are working on has been switched OFF.

Installation directions

Remove the mounting bracket from the body of the fitting by loosening the screws on the top using a spanner (not included).
Use the mounting bracket as a template to mark the screw positions onto the wall.
Drill holes into the wall and push the plastic anchors into the holes.
Install the mounting bracket onto the wall by using the mounting screws and rubber washers provided.
Ensure the screws used are suitable for the mounting surface.
Loosen the screws on the cord anchorage system and insert the main supply wire through the gasket leading to the terminal block.
Connect the mains supply wire to the terminal block provided. Ensure that the wires are secure and no bare wires are exposed.
Mains Supply Wire Fitting Wire
Earth – Yellow/Green Yellow/Green
Neutral – Blue or Black Blue
Live – Brown or Red Brown
Place the mains supply wire in the cord anchorage system and secure by tightening the screws.
Install the fitting back onto the mounting bracket and tighten the two screws on the top.
Adjust the heads of the fitting to the desired direction.

Safety tips

Always ensure the power is OFF and the fitting has cooled down before performing any maintenance, cleaning, or adjustment to the fitting.
To avoid injury or damage to the fitting, ensure that power leads and screws are secure before connecting the power.
Select a suitable location away from liquids and hazards.
Ensure that the fitting does not come in contact with corrosive chemicals, etc.
To clean, wipe with a damp clean cloth. Never soa k the fitting with water.