LIT LOGOS FT-86 LIT Flat Surface Installation Guide

LIT LOGOS FT-86 LIT Flat Surface

INCLUDED PARTS

• 1 -Lit Logos Control Box
• 1 -Lit Logos BRZ/GT86/FRS/TRD logo
• 1 -3M Strip (pre-applied)
• 1 -Lit Logos decal

HOW TO INSTALL

1. Disconnect the car battery

2. Find a flat surface you want to mount the logo to. Route the control box connector to the area you want to mount the logo to.
   You may need to remove the bumper to route the wire.

3. Connect the Lit Logo to the Contol Box using the waterproof quick disconnect. EnsurEnsure the that the arrt the arrows
   line up on the connector line up on the connector and the r and the red gasked gasket is in place.et is in place. TThrhreead the locking nut into place all the way to ensurad the locking nut into place all the way to ensure ae a waterproof connection. connection.

4. Remove the backing from the 3M and adhere the logo where you want it to be. Keep constant pressure on it for at least 60 seconds.
   Ensure the surface you are mounting the logo to is clean to allow for a strong bond.

5. Find where you want to connect the logo to power. Any 12V power source will work so you can select a fuse, headlight wire, or even wire it directly to the battery.
   A 5a fuse must be used with ANY power source you use. Most commonly with an inline fuse connected directly to the car battery.

6. Route the power and ground wire from the control box to the location you chose to power the logo, avoiding any high heat or moving parts.

7. Tuck the Control Box out of the way, but still within reach of the front bumper where you installed the logo.
   Be sure to place this somewhere that wont be hit by road debris, direct water, or high heat. This is the brains of the Lit Logo. It is water and heat resistant, but high pressure water or extreme temperatures can damage the electronics.

8. Re-connect the car battery.

LED HUE BLUETOOTH APP

Download the LEDHue app from the App Store/Google Play store. Below are some tips for using the LEDHue app to control your Lit Logo:

TROUBLESHOOTING STEPS

We hope you never have any issues with your logo, but if you do, here are the best steps to take to get it working again as quickly as possible:

• Turn off Bluetooth on your phone, uninstall and reinstall the app, and try to connect to the logo again
• Ensure the ground source is clean and connected directly to unpainted metal. We recommend connecting the ground wire to the same location the battery is grounded to
• Try a different power source. Sometimes a fuse tap wont reach far enough into the fuse or the wire wont provide enough power, so try connecting the logo directly to the battery with an inline fuse
• Check the app and ensure the logo is set to “GRB SK6812_RGBW” and the pixels should be set to 15
• Make sure the logo is switched to the “on” position in the app
• Make sure that the bottom slider on the app control is turned all the way down
• Make sure that the top slider on the app control is turned all the way up
• Try using a different phone to connect to the logo
• Check that the arrows on the quick disconnect between the logo and the control box are pointing towards each other
• Disconnect the logo from power and leave off for 12 hours

6839 CORALBERRY LN N, JACKSONVILLE, FL 32244
P: 866-548-5646
WWW.LIT-LOGOS.COM

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>