JBL WAVE 100 TWS Ear Headphones User Guide
- June 9, 2024
- JBL
Table of Contents
JBL WAVE 100 TWS Ear Headphones
WHAT’S IN THE BOX
how to wear
- Try different sizes of eartips for the best fit and seal.
FIRST TIME USE
power on & CONNECT
DUAL CONNECT
BUTTON COMMAND
- Stereo Mode
- Mono Mode
power off
Manual Controls
- Connect to a new Bluetooth device
- RECONNECT LEFT &
- RIGHT ReSET
Charging
led behaviors
TECH SPEC
- Model: WAVE100TWS
- Driver Size : 8 mm / 0.31” Dynamic Driver
- Power supply: 5 V 1 A
- Weight: 46.3 g / 0.102 lbs
- Earpiece: 5.1 g / 0.011 lbs (10.2 g / 0.022 lbs combined )
- Charging case: 36.1 g / 0.08 lbs
- Headset battery type: Lithium-ion Battery (45 mAh / 3.7 V)
- Charging case battery type: Lithium-ion Battery (550 mAh / 3.7 V)
- Charging time : 2 hrs from empty
- Music playtime with BT on up to 5 hrs
- Frequency Response: 20 Hz – 20 kHz
- Impedance: 16 ohm
- Sensitivity: 105.5 dB SPL@1kHz
- Maximum SPL: 94 dB
- Microphone sensitivity: – 11.3 dBV@1 kHz / Pa
- Bluetooth version: 5.0
- Bluetooth profile version: A2DP V1.3 AVRCP V1.6 HFP V1.7
- Bluetooth transmitter frequency range: 2.4 – 2.4835 GHz
- Bluetooth transmitter power : < 10 dBm
- Bluetooth transmitter modulation: GFSK, π/4-DQPSK, 8-DPSK
- Maximum operation temperature : 45°C
IC RF Exposure Information and Statement
The SAR limit of Canada (C) is 1.6 W/kg averaged over one gram of tissue.
Device types: (IC: 6132A-JBLV100TWS) has also been tested against this SAR
limit According to this standard, the highest SAR value reported during
product certification for head use is 0.59W/kg.The device was tested for
typical bodily operations where the product was kept 0 mm from the head. To
maintain compliance with IC RF exposure requirements, use accessories that
maintain a separation distance of 0mm between the user›s head and the back of
the headset. The use of belt clips, holsters and similar accessories shall not
contain metal parts in its assembly. Use of accessories that do not meet
these requirements may not comply with IC RF exposure requirements and should
be avoided.
Head operation
- The device was subjected to a typical head manipulation test. In order to comply with RF exposure requirements, a minimum separation distance of 0 cm must be maintained between the user›s ear and the product (including
the antenna). Head exposure that do not meet these requirements may not meet RF exposure requirements and should be avoided. Use only the supplied or approved antenna.
IC: 6132A-JBLV100TWS
-
The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such marks by HARMAN International Industries, Incorporated is under license. Other trademarks and trade names are those of their respective owners.
-
This product is homologated by Anatel, in accordance with the regulated procedures for conformity assessment of telecommunications products and meet technical requirements applied. For more information, consult the Anatel website – www.anatel.gov.br This equipment is not entitled to protection against harmful interference and may not cause interference in duly authorized systems.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>