Trust ZCTS-808 Zigbee Wireless Contact Sensor User Manual
- June 4, 2024
- Trust
Table of Contents
Trust ZCTS-808 Zigbee Wireless Contact Sensor
COMPATIBILITY
The contact sensor works with the Z1 ZigBee Bridge and the ICS-2000/Smart Bridge.
REPLACE THE BATTERY
- Remove the backplate from the contact sensor.
- Open de battery cover using a flat screwdriver.
- Place the included CR2032 battery in the contact sensor. Note the positive and negative polarity in the compartment. Close the battery cover.
INDICATORS
The contact sensor contains a LED indicator (This is not a button) to show the status of the contact sensor. Please see below the meaning of the different LED indications.
LED FUNCTION TABLE
| Connection mode | LED will flash once per second for approximately 1 min. |
|---|---|
| Connected successfully | LED will stop flashing |
| Sensor reset | LED will flash fast |
| Sensor triggered (When the sensor is opened for more then 10 mm) | LED will |
flash once
DOWNLOAD APP
- www.trust.com/zigbee
- To connect the contact sensor with a Z1 ZigBee bridge or ICS-2000/Smart Bridge, first, get the App by scanning the QR code or go to trust.com/zigbee and install it.
CONNECT SENSOR
- In the App, select a room, press the + button, and follow instructions. For manual set up of pushnotifications go to the rules tab, press the + button and select notification wizard.
MOUNT THE CONTACT SENSOR
Note: When mounting the contact sensor make sure both parts are mounted with as little space between as possible (max. 5mm). Remove the backplate by sliding it off the contact sensor and attach it with the included screws to a flat surface. Attach the small part of the contact sensor using the double- sided tape on the back and place the contact sensor on the backplate.
RESET THE CONTACT SENSOR AND ACTIVATE CONNECT MODE
Warning: This step will remove the sensor from the Z1 ZigBee Bridge or the ICS-2000/Smart Bridge. To reset the sensor press the button in the hole at the side of the sensor for approximately 5 sec with the included pin. The LED will flash fast to confirm the reset.
Activate connect mode: After resetting the sensor you can activate the connect mode by pressing the reset button for approx. 1 sec.
The wireless range increases when you add more ZigBee products (meshing). To learn more about meshing go to trust.com/zigbee
References
- Trust.com - Home
- Trust.com - Contact & Support - Installation of ZigBee products
- Trust.com - Contact & Support - Installation of ZigBee products
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>