maytronics 99996155-US Dolphin Encore Robotic Pool Cleaner User Guide

June 16, 2024
maytronics

maytronics 99996155-US Dolphin Encore Robotic Pool Cleaner

Quick start guide

Thank you for purchasing Mytronics Robotic Pool Cleaner.
The Robotic Pool Cleaners by Maytronics deliver advanced cleaning technologies, long lasting performance and easy maintenance. You and your family will be free to enjoy swimming with full confidence that your pool is completely clean.

Cautions & Warnings

  • Use the originally supplied power supply only.
  • Do not use an extension cable in any case whatsoever.
  • Ensure the electrical outlet is protected by a ground fault interrupter (GFI) or an earth leakage interrupter.
  • Keep the power supply out of standing water.
  • Do not enter the pool while the Pool Cleaner is working.
  • Unplug the power supply before servicing.
  • Do not use the cable to take the pool cleaner out of the water.
  • Use the Pool Cleaner in the following water conditions only: Chlorine Max 4 pm;
    pH 7.0 – 7.8; Temperature 6 -34°C (43-93°F);
    NaCi Maximum = 5000 ppm.

Digital Power Supply

Input: 100-125 AC Volts 50-60 Hertz 120 Watt
Output: <30 VDC IP 54

Specifications:

  • Motor protection: IP 68
  • Minimum depth: 0.80m/2.6ft
  • Maximum depth: 5m/16.4ft

Helpful hints

  • When working, the Power Supply should be placed in the shade.

  • If the Dolphin is fitted with combined or wonder brushes, gently squeeze the brushes until they are soaked with water.
    Release minimal required floating cable length to ensure proper pool coverage.
    Leave excess cable rolled outside the pool.

  • After each cleaning cycle wash the filters or cartridge. Clogged filters reduce scanning and cleaning efficiency

  • To remove the kinks stretch the cable out completely and let it sit for at least a day in the sun.

  • Store the pool cleaner in a shady place on its Caddy, if not on a caddy, place the pool cleaner upside down.

Robot operation

Set Up

  1. Attach the floating cable to the power supply.

  2. Position the power supply at least 3.5m /12ft away from the edge of the pool.

  3. Put the Pool Cleaner into 1 the pool. Release the Pool Cleaner and let it sink to the floor of the pool. Make sure that the floating cable is free of any obstructions.

  4. Turn the power supply ON. the pool cleaner will now operate until it has reached the end of the cleanino cvcle.

  5. Cleaning the filter
    It is highly reccomended to clean the filter basket after each cleaning cycle.
    Note: Don’t let the filter cartridges dry out before cleaning.

Maintenance

Periodic filter cleaning
Dismantle the 2 ultra-fine filter panels of the outer basket according to the following steps:

Cleaning the impeller
If you notice debris trapped in the impeller:
Unplug the power supply before servicing
Clean the debris trapped in the impeller opening, according to the following steps:

  1. If the debris is not reachable follow the next steps.
  2. Using a short screwdriver open the 2 screws.

For a detailed manual (including videos
manuals.mavtronics.com/en

www.maytronics.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals