SIEMENS MPI-2 Mounting Plate Instruction Manual
- June 9, 2024
- SIEMENS
Table of Contents
SIEMENS MPI-2 Mounting Plate
Installation Instructions
Model MPI-2 Mounting Plate
OPERATION
The Model MPI-2 Mounting Plate from Siemens Industry, Inc., is used to mount TRI-S, TRI-D, or TRI-R addressable devices onto a System 3 Rail Assembly. The MPI-2 occupies two module spaces on the rails. The mounting plate can be used for a single TRI-S, TRI-D, or TRI-R device or for any two of the TRI devices, mixed types or the same type.
Note: Refer to the System 3 Control Panel Installation Instructions, P/N 315-093680, for power limited and non-power limited wire routing.
INSTALLATION
Using the four 8 x 1/4 Phillips head screws provided, mount the MPI-2 plate to the rail assembly at the upper and lower corners of the plate labeled position A in the figure. Install one or two TRI-S, TRI-D, or TRI-R modules on the MPI-2 plate as shown in the figure, using 4 of the 8 x 1/4 Phillips head screws provided for each TRI module. Fasten the BP-30 cover plate in the System 3 door so as to cover the MPI-2 plate.
Siemens Industry, Inc. Building Technologies Division Florham Park, NJ P/N 315-096447-5 Siemens Building Technologies, Ltd. Fire Safety & Security Products 2 Kenview Boulevard Brampton, Ontario L6T 5E4 Canada