Pearl Mantels 416 Devonshire Mantel Shelf User Manual
- June 9, 2024
- Pearl Mantels
Table of Contents
Pearl Mantels 416 Devonshire Mantel Shelf
Thank you for your purchase of the 416 Devonshire Mantel Shelf!
You have the option of installing your shelf with or without the corbels that
have been included in your purchase.
If you decide not to use the
corbels, please proceed to Installation using the Hanger Board How to install
the corbels
Your shelf has wooden nuts placed in the bottom of the beam.
-
Turn the shelf upside down on a soft surface.
-
Tap out the wood nuts using a flat head screw driver and hammer (or a similar method).
You will be left with holes on each end of the shelf. -
Put the washers onto the bolts.
-
With the shelf still upside down line up the pre threaded inserts of the corbels with the holes in the bottom of the beam.
-
Before installing, insert the bolts through the holes in the bottom of the shelf and tighten into the threaded inserts.
Installation using the Hanger Board
For hanging your shelf, we suggest that you use the hanger board included in this box. The type of hardware (not included) you will use for mounting your hanger board will depend upon the medium your shelf will be attached to (i.e. brick, stone, drywall…). Please consult a professional for advice on the proper hardware.
Measuring
The hanger board measurement should be taken from the floor or the hearth to
the bottom edge of the hanger board. Mark your recorded measurement on your
wall, both left and right. Take the wall hanger board and mount it on the wall
so that the bottom edge of the board is on your recorded marks. Check to see
that your wall hanger board is centered over your firebox before mounting.
Once mounted, if the shelf doesn’t seem to fit snugly to the wall, you may put a small shim of paper, cardboard, etc., to fill the gap where the 2 halves of the hanger board meet.
Suggested Preparation Prior to Painting or Staining of Wood Mantels
Lightly sand your shelf before painting or staining. Wipe clean. Use a
solvent to remove any excess glue. If painting, we suggest that a primer be
used before applying your top coat. We also suggest that you follow the
paint/stain manufacturer’s recommendations for application.
The hanger board is only a suggested method. Your installer may also have
additional methods for mounting your mantel or shelf. We suggest that pilot
holes be drilled prior to inserting the appropriate hardware for final
installation on the wall surface.
Wood and MDF mantels are considered combustible materials. Heat clearances
must be adhered to. Before installing,
check your local building codes and the manufacturer’s instructions for your
specific fireplace insert or stove.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>