VIVO BIKE VT2822 Torino Bike User Guide
- June 9, 2024
- VIVO BIKE
Table of Contents
VIVO BIKE VT2822 Torino Bike
Instruction
Dear Biker, thank you for purchasing a VIVO Torino.
We are sure that you are as environmentally conscious as we are and for this
reason we have chosen to print this quick assembly guide. To consult the
complete User Manual, visit the link https://www.vivobike.it/ or scan the QR
Code below:
To start using the bike, pull it out from the cardboard packaging carefully. Remove all used cable ties and tape to keep the packaging secure a bike protection. Making sure the bike rests on a at surface, continue to assembly following this order:
DISPLAY
To turn the display on or o, hold down the button for 3 seconds.
Change the Pas values with and . To turn the lights on or off, press the button
.
To enter the settings menu, hold button + button together for 3 seconds. For
all the other functions that can be activated by the buttons, refer to the
User Manual.
-
FRONT FENDER ASSEMBLY
Loose the screw and the nut of the front light, position it on the fork bracket and proceed by screwing the bolt again, using the sequence as the picture. Then, do the same with the two screws (one on each fork legs) of the fender support. -
FRONT WHEEL ASSEMBLY
Loosen nuts and washers on each side of the hub. Insert the wheel inside its seats on the fork legs and proceed with the tightening. Pay attention to the safety washer which must be locked with its hook in the appropriate hole on the fork foot.
-
PEDALS ASSEMBLY
Take the pedals from the accessory box. The right one is indicated with the letter R and has a right-hand thread (it is screwed clockwise, it is unscrewed counterclockwise). The left one is indicated with the letter L and has a left- hand thread (it is screwed counterclockwise, it is unscrewed clockwise). Be careful not to reverse the pedals. -
SEAT ASSEMBLY
Install the saddle in its seat in the frame with the collar open. Close the collar and check that the saddle itself does not move. In the case of
moving, reopen the collar and tighten the screw on the opposite side.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>