MATSON MAPP300 Lithium Portable Power Station User Manual
- June 9, 2024
- Matson
Table of Contents
MATSON MAPP300 Lithium Portable Power Station User Manual
⚠ WARNING Please read the user manually carefully before using this product WARNING
IMPORTANT INFORMATION
-
Children must be supervised when using this product
-
Only use safe, certified electrical products with this device
-
Only operate this product in a well ventilated area
-
Only operate the product in dry areas to reduce the risk of electric shock
-
Remove the power plug when the product is not in use
-
Do not expose the product to fire or excessive heat
-
Do not disassemble, there are potentially dangerous electrical components inside.
Any service or repair must be performed by an authorised Tridon repairer -
Do not use the product with any damaged wires, plugs or cables to avoid the risk of electric shock
-
The 240VAC can only operate devices that use less than 300 Watts. The unit will automatically shut down if this limit is exceeded.
-
The 240VAC port will turn off automatically after 45 mins if the current draw is less than 1 watt
-
The DC outlets and cig socket will turn off automatically after 8 hours if the current draw is less than 1 watt
INSTRUCTIONS
-
Check power station is dry and undamaged
-
Plug your device into the appropriate outlet socket and press the corresponding on/off button
– DC for DC ports
– USB for USB ports
– AC for AC ports A beep will sound and the screen will show the icon that matches your choice. Your device should now be powered -
When finished, press the same corresponding button to turn off that port
NOTE
The device will turn off automatically a short period after you switch off
your output port. Recharge the power station every 3 months when not in use
Store in a cool, dry place
LCD SCREEN
The screen will display the % state of charge, the remaining run time and the wattage being used in real time. It also indicates which output ports are switched on (AC/USB/DC)
SPECIFICATION
SUPPORT CHARGING DEVICE
USB port: Smart phones, tablets, smart watches, digital cameras, e-readers,
etc.
12V Car charger port: Car charger
DC output: Drones, routers, car refrigerators, etc. use 12V as the power
supply device
AC power: Laptops, displays, appliances, etc.
CHARGING METHOD
Fully charge before use, and before storing. To charge, insert either the wall charger, car charger or your solar charger into the DC Input port
LED LIGHT
Press once to get low light, press twice to get high light, press three times to get SOS, press four times to turn off the light.
DISPOSAL
Please dispose of this device responsibly, check local regulations for the disposal of lithium batteries.
TERMS AND CONDITIONS OF WARRANTY
Products developed and sold by Tridon Australia Pty Ltd come with a guarantee
for the reasonable life of the product, for the purpose it is commonly used.
This is in addition to the rights of the consumer under the Australian
Consumer Law. To be considered for warranty please take the product with proof
of purchase to the store where you purchased the product or contact Tridon
Australia
The warranty is given by: Tridon Australia, 21-25 Derby St, Silverwater, NSW
2128. Tel: 1300 362 263.
Email: mail@tridon.com.au
Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for a major failure
and for compensation for any other reasonably foreseeable loss or damage
incurred if the product fails when used for the purpose for which it was
intended. You are also entitled to have the goods repaired or replaced if the
goods fail to be of acceptable quality and the failure does not amount to a
major failure.
Tridon Australia will bear costs associated with claiming legitimate
warranties. Proof of expenses incurred must be submitted to Tridon Australia
Pty Ltd.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>