airLive Live-8GT 8-Port SOHO Gigabit Switch User Guide
- June 9, 2024
- airlive
Table of Contents
Live-8GT
8-Port SOHO Gigabit Switch
Quick Setup Guide
Installation Steps
Figure A
LED DEFINITIONS
Power | Red ON | Power is on and normal. |
---|---|---|
Red Off | The switch is not receiving power. | |
Loop | Green ON | Port loop. |
Green Blinking | Port normal. | |
Port | Green ON | Link connected. |
Green OFF | Link disconnect. | |
Green Blinking | Data transmisson. |
Mode Switch Control
VLAN| Port isolation mode. In this mode ports 1~6 cannot communicate with each
other and can only communicate with the Up-Link port 7/8.
---|---
Default| Normal mode. All ports can communicate with each other. Loop Support.
Extend| Extension mode. Data transmission distance can be extended to 250
meter at a transmission rate of 10Mbps Port 1~6 only. 1~6 Ports support 100M
Speed reducation negotiation, 250 meters in 10Mbps mode, Port 7 and Port 8 as
Uplink Port at 1000Mbps.
Installation Step:
- Remove the switch and accessories from the package.
- Connect power to the switch. Make sure that “Power” LED is on.
- Check the Port LED indicator status. When a device is connected the port light up.
- For more product information visit www.airlive.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>