GAINSBOROUGH L105 Rabbit Family Solar Ornament Instructions

: June 9, 2024
: GAINSBOROUGH

Table of Contents

GAINSBOROUGH L105 Rabbit Family Solar Ornament
ALWAYS POSITION IN DIRECT SUNLIGHT
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE
MAINTENANCE AND TROUBLESHOOTING
BATTERIES
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

GAINSBOROUGH L105 Rabbit Family Solar Ornament

ALWAYS POSITION IN DIRECT SUNLIGHT

Dimensions
(H) 18.5 x (W) 18.5 x (D) 9cm Material: Resin

SOLAR GARDEN LIGHT WITH AN ADORABLE RABBIT FAMILY
MADE FROM TOUGH WEATHERPROOF RESIN
SOLAR POWERED
AUTOMATICALLY ILLUMINATING AT NIGHT

Battery: 1x Ni-MH AA 300mAh 1.2V REPLACABLE, RECHARGEABLE

ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE

Unpack the components carefully. Please check all parts have been removed from the packaging.

Before using first time
Allow lamp to charge for at least 8 hours in full sunlight with the ON/OFF switch in the ON position. The ON/OFF switch is usually located below or next to the solar panel. Once the batteries are fully charged, leave the ON/OFF switch to ON. If the lamp does not turn on after dark refer to Maintenance section.

Find an ideal Place for the Solar Light.
Place the solar light in an area where it will receive direct sunlight for at least 8 hours per day. The number of hours the light will illuminate is directly proportional to the hours of sunlight it receives. If the light is placed in a shaded area, it will not be able to fully charge and its illumination time will be limited. Do not place the light near other outdoor lighting like porch or streetlights. These may fool the sensor and keep the light from coming on, or cause it to turn off automatically

MAINTENANCE AND TROUBLESHOOTING

Make sure the switch is set to “ON” position.
Keep the solar panel clean.
Battery 1pc AA “ 1.2v 300Mah, Ni-MH, Rechargeable, replaceable).

Care and Maintenance Recommendations

Clean solar panel with a soft sponge every couple of weeks.
Make sure all connectors are still tight and no water getting in.

Battery replacement:

Step1: Unscrew the battery compartment cover by using a Phillips head screwdriver (not included) .
Step2: Remove the exhausted battery and install AA “ 1.2v 300Mah, Ni-MH, Rechargeable battery according to the +/- polarity as beside image. Open the compartment carefully and ensure that welding wires inside the battery terminals are not damaged.
Step3: Replace battery compartment cover, screw it back into position and make sure is properly sealed.

BATTERIES

Keep batteries away from children and pets.
Do not mix used and new batteries.
Remove the batteries if left for long periods.
Never dispose of batteries in a fire.
Battery disposal, spent or expired batteries must be properly disposed of and recycled in compliance with local regulations. For detailed information, contact your local authority.
Follow the battery manufacturer’s safety, usage, and disposal instructions.

DISPOSAL

Coopers of Stortford use recyclable or recycled packaging where possible.
Please dispose of all packaging, paper, cartons, packaging in accordance with your local recycling regulations.
At the end of the product’s lifespan please check with your local council authorised household waste recycling centre for disposal.
Plastics, polybags – this is made from the following recyclable plastic.

The Enterprise Department
UK Head Office, 11 Bridge Street, Bishop’s Stortford, CM23 2JU Tel: 0844 4824400, Fax: 01279 756595 www.coopersofstortford.co.uk EU address: D.S.B. LD, 160 Bd. de Fourmies, 59100 Roubaix, France Tel: (+44) 1279 701269 UK Calls cost around 7 pence per minute plus your telephone company’s network access. Please check with your telephone supplier.