LENNOX S40 Wireless Extender User Guide
- June 9, 2024
- Lennox
Table of Contents
LENNOX S40 Wireless Extender
IMPORTANT
DO NOT paint the smart device. Doing so will prevent components from functioning correctly
OVERVIEW
Wireless Extender Buttons and LED Indicator
-
Download and install the Lennox® Smart Technician App if not already installed on your mobile device.
-
The following procedure is assuming the Lennox® S40 Smart Thermostat has already been commissioned. From the thermostat home screen, go to Menu > Settings > Advanced Settings > View Support Service Control Center and select Connect To Lennox Smart Technician App.
-
The thermostat will start broadcasting its Thermostat ID.
-
Start the Lennox® Smart Technician App and follow the screen prompts until you reach Service Center.
-
To add a smart device, select Equipment Settings > Add Device.
-
Plug the smart device into a power outlet that is between the locations of the smart device and the Lennox® S40 Smart Thermostat.
NOTA: The wireless extender will broadcast its ID for three minutes. To restart the broadcast ID, press the pairing button for two seconds. -
Follow the screen prompts to add the smart device.
-
Confirm that the wireless extender is installed between the affected smart room sensor and the Lennox® S40 Smart Thermostat.
-
Walk the homeowner through on where to find and download the Lennox® Smart Thermostat App. Refer to the Lennox® S40 Smart Thermostat User Guide on how to use the smart device.
Scan QR Code for
lennoxsmartertogether.com/dealer-access
ennoxsmartertogether.com/spanish-french
References
- Home | Support Center - Lennox Smarter Together
- Translations | Support Center - Lennox Smarter Together
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>