SECOMP 12991105 USB 3.2 Gen 1 to Gigabit Ethernet Converter User Manual
- June 9, 2024
- SECOMP
Table of Contents
USB 3.2 Gen 1 to
Gigabit Ethernet Converter
12.99.1105
User Manual
12991105 USB 3.2 Gen 1 to Gigabit Ethernet Converter
DEAR CUSTOMER
Thank you for purchasing this product. For optimum performance and safety,
please read these instructions carefully before connecting, operating or
adjusting this product. Please keep this manual for future reference.
INTRODUCTION
The USB 3.0 to Gigabit Ethernet Adapter is a high performance and low-cost solution. It enables Gigabit Ethernet network connection capability for desktops, ultra book with standard USB port. It resolves the trouble of the computer without Ethernet port that you can also connect computer to Ethernet through USB 3.0 port easily.
FEATURES
Single chip USB 3.0 to 10/100/1000M Gigabit Ethernet controller with Energy Efficient Ethernet (EEE). Features as below:
- Integrates on-chip USB 3.0 PHY and controller compliant to USB Spec 3.0,2.0 and 1.1
- Supports all USB 3.0 power saving modes (U0, U1, U2, and U3)
- Supports USB Super/High/Full Speed modes with Bus-power or Self-power device auto-detect capability
- Supports IEEE 802.3az (Energy Efficient Ethernet)
- Supports parallel detection and automatic polarity correction
- Supports IPv4/IPv6 packet Checksum Offload Engine (COE) to reduce CPU loading
- Supports TCP Large Send Offload V1
- Supports full duplex operation with IEEE 802.3x flow control and half duplex operation with back-pressure flow control
- Supports IEEE 802.1P Layer 2 Priority Encoding and Decoding
- Supports Jumbo frame
- PHY loop-back diagnostic capability
- Support Wake-on-LAN Function
- Supports suspend mode and remote wakeup via link-change, Magic Packet, Microsoft Wakeup Frame and external wakeup pin
- Support windows 8, windows 7, windows vista, Apple 10.6 and Apple 10.8
SPECIFICATIONS
Connectors
USB 3.0| USB Male
Ethernet| RJ45 Female
Power Requirement|
External Power Supply| No
Power consumption (Max)| 0.5W
Note: Specifications are subject to change without notice.
PACKAGE CONTENTS
Before attempting to use this unit, please check the packing and make sure the following items are contained in the shipping carton:
- Main unit x1
- User’s Manual x1
- CD driver x1
PANEL DESCRIPTIONS
-
USB3.0
Connect the port to the PC Host. -
RJ45
Connect the port to the Ethernet Router or Networking by a Networking cable.
CONNECTION AND OPERATION
1) Driver installation
Drive specific installation process please refer to the CD Manual.
2) Connection
① Connect computer to USB 3.0 port of this product
② Connect RJ45 of this product to Ethernet Router by Ethernet cable
③ automatically or manually set IP address of computer.
5.1 CONNECTION DIAGRAM
Documents / Resources
|
SECOMP 12991105 USB 3.2 Gen 1 to Gigabit Ethernet
Converter
[pdf] User Manual
12991105, USB 3.2 Gen 1 to Gigabit Ethernet Converter, 12991105 USB 3.2 Gen 1
to Gigabit Ethernet Converter, Gigabit Ethernet Converter, Ethernet Converter,
Converter
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>