LENNOX S40 Smart Room Sensor User Guide
- June 9, 2024
- Lennox
Table of Contents
LENNOX S40 Smart Room Sensor
IMPORTANT
DO NOT paint the smart device. Doing so will prevent the occupancy sensor and
other components from functioning correctly
NOTE: LED light pipe is not visible on top of plastic surface. User will
see illumination on the front plastic when LED is on.
OVERVIEW
INSTALLATION STEPS
-
Download and install the Lennox® Smart Technician Service App if not already installed on your mobile device.
-
The following procedure is assuming the Lennox® S40 Smart
Thermostat has already been commissioned. From the thermostat home screen, go to Menu > Settings > Advanced Settings > View Support Service Control Center and select Connect To Lennox Smart Technician App. -
The thermostat will start broadcasting its Thermostat ID.
-
Start the Lennox® Smart Technician App and follow the screen prompts until you reach Service Center.
-
To add a smart device, select Equipment Settings > Add Device.
-
Open the case and remove the insulation tape from the AA lithium batteries. Once the tape is removed the smart device will start broadcasting its ID automatically.
NOTA : The SRS will broadcast its ID for three minutes. To restart the broadcast ID, press the pairing button for two seconds. -
Follow the screen prompts to add the smart device.
-
Confirm the desired sensor location has adequate signal strength.
No LED light indicates the smart device is within range, blue LED light indicates weak signal. The Lennox® Wireless Extender (sold separately) is recommended when a location does not have a strong signal strength. -
Install the smart device on an interior wall (see Figure 2) at a minimum height of 5 feet (1.52 meters) or place on the stand. For more recommendations on placement of room sensors, please download the installation guide.
-
It is recommended that the smart device is installed on a wall to ensure it will not be lost or damaged. Use the provided screws and wall anchors.
-
A wall template is also included for the smart device installation.
-
If not installed on a wall, use the included stand. Use the stand to place the smart device above the ground on a table or shelf out of reach of children and pets.
-
Walk the homeowner through use of the smart device including where to find and download the Lennox® Smart Thermostat App. Refer to the Lennox® S40 Smart Thermostat User Guide on how to use the smart device.
Scan QR Code for Installation and Setup Guide
lennoxsmartertogether.com/spanish-french
lennoxsmartertogether.com/dealer-access
References
- Home | Support Center - Lennox Smarter Together
- Translations | Support Center - Lennox Smarter Together
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>