QwikProducts QT2000 QwikCheck Acid Test Kit User Guide
- June 4, 2024
- QwikProducts
Table of Contents
QwikProducts QT2000 QwikCheck Acid Test Kit
Instructions
QwikCheck is ideal for preventive maintenance checks and for verifying proper
acid clean up. The QwikCheck indicator paper is golden yellow before testing
and will turn pink or red upon being exposed to as little as 1 part per
million (PPM) of acid.
Perform a Qwik acid test on operating systems. Ideal for preventative
maintenance checks or for verifying proper acid clean-up after a compressor
burn-out /change-out
- 2-Second Refrigeration Acid Test
- Tests to ARI-700 limit of 1 PPM
- Tests for Inorganic Acid (including POE)
- Meets EPA Venting Rules
Directions:
- Insert the valve core depressor into the center of the suction side of the vapor service valve while the system is operating.
- Allow vapor to flow through the QwikCheck for 2-seconds. If the indicator paper does not change color, hold for another 2-seconds. If the indicator paper still does not change color, inorganic acid was not detected.
- If the indicator paper changes color slightly, add QwikShot® to remove the acid. If the paper turns red, the acid level is very high. Change the oil and the filter-drier, and then add QwikShot.
For more details or information about QwikCheck visit
www.qwik.com
QwikCheck 2-Second Acid Test Kit – Part # QT2000
U.S. Patents #6,514,765 & #5,770,048
QwikProducts®, QwikCheck®, and QwikShot® are registered trademarks of
Mainstream Engineering Corporation, Rockledge, Florida 32955,
321-631-3550 All QwikProducts® are made
in the USA. © 2021 Mainstream Engineering Corporation
Mainstream Engineering Corporation
1-800-866-3550
www.qwik.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>