S330 EufyCam Add-On Camera User Guide

June 9, 2024
Eufy

S330 EufyCam Add-On Camera User Guide

S330 EufyCam Add-On Camera User Guide

AT A GLANCE

S330 eufyCam
Model: T8160

  1. Spotlight
  2. Solar Panel
  3. Speaker
  4. Camera Lens
  5. LED Indicator
  6. SYNC Button
  7. Photosensitive Sensor
  8. Microphone 2
  9. Mounting Hole
  10. Microphone 1
  11. Motion Sensor
  12. USB-C Charging Port

S380 HomeBase
Model: T8030

  1. Status LED
  2. Hard Drive Bracket
  3. USB Port 2
  4. Reset Hole
  5. SYNC / ALARM OFF Button
  6. Ethernet Port
  7. Speaker
  8. USB Port 1
  9. Power Port

EXPANDING STORAGE (OPTIONAL)

S380 HomeBase comes with 16 GB of storage for saving video recordings and allows you to add an additional hard drive to expand the space.

Prepare Your Hard Drive

Your hard drive must meet the following requirements:

S330 EufyCam Add-On Camera User Guide - Prepare Your Hard
Drive

⚠ Transfer all the data in your hard drive to a secure location before adding it to S380 Home Base.

S330 EufyCam Add-On Camera User Guide - Transfer all the data in your hard
drive

Install Your Hard Drive
⚠ S380 HomeBase must be powered off when you install or remove a hard drive.

  1. Push down the top lid to remove it.
  2. Loosen the screw, then pull out the hard drive bracket.
  3. Fix your hard drive to the bracket with the provided screws. HARD DRIVE
  4. Insert and screw the bracket back to S380 HomeBase, then put the top lid back into place.

S330 EufyCam Add-On Camera User Guide - Insert and screw the bracket back to
S380 HomeBas

  • You can follow the steps above to expand the storage whenever necessary.
  • A new hard drive must be initialized through the eufy Security app to work with S380 HomeBase.

SETTING UP

  1. Power and connect S380 HomeBase to your router. The LED indicator will turn blue (This may take about 1 min) when S380 HomeBase is ready for setup.

  2. Download and install the eufy Security app, then sign up for an account.

  3. Follow on-screen instructions to add S380 HomeBase and the cameras to your device list *).

S330 EufyCam Add-On Camera User Guide - Follow on-screen instructions to add
S380 HomeBase and the cameras

  • One S380 HomeBase can pair up to 16 cameras.

CHARGING THE CAMERA

Fully charge both cameras before first use. This may take about 8 hours for each.

S330 EufyCam Add-On Camera User Guide - Fully charge both cameras before
first use

S330 eufyCam includes a solar panel that converts sunlight into electrical energy and keeps the built-in battery charged every day.
The charging efficiency fluctuates according to the intensity of the sunlight.
Don’t worry when the battery level goes down. It happens when there isn’t enough sunlight or the camera is consuming more power than usual. You don’t need to charge the camera with a cable until a low battery alarm goes off.

**2 HOURS PER DAY***

  • Make sure the solar panel can be fully exposed to direct sunlight for at least 2 hours per day.

MOUNTING THE CAMERA

S330 EufyCam Add-On Camera User Guide - MOUNTING THE
CAMERA S330 EufyCam Add-On Camera User
Guide - MOUNTING THE CAMERA

SAFETY

– Do not use the device in the environment at a too high or too low temperature, never expose the device to strong sunshine or too wet environment.
– The suitable temperature for T8030 and accessories is -10°C to 45°C .
– The suitable temperature for T8160 and accessories is -20°C to 50°C (Charging temperature is 0°C to 45°C) .
– It is recommended to supply the device in an environment with a temperature that ranges from 5°C~25°C.
– When supplying, please place the device in an environment that has a normal room temperature and good ventilation.
– The adapter shall be installed near the equipment and shall be easily accessible.
– Please ensure to use only the adapter offered by the manufacturer. Using unauthorized adapter may cause danger and violate the authorization of the device and the guarantee article.
– This adapter is for indoor use only. The adapter type (for S380 Home Base) is KA2401A-1202000US, rated output voltage/current is 12 Vdc/2A. The plug is considered as disconnect device of adapter. Warning:
– Replacement of a battery with an incorrect type can defeat a safeguard;
– Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery can result in an explosion;
– Leaving a battery in an extremely high temperature surrounding environment can result in an explosion or the leakage of flammable liquid or gas; and
– A battery subjected to extremely low air pressure may result in an explosion or the leakage of flammable liquid or gas.

⚠ CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
⚠ CAUTION: LITHIUM COIN CELL BATTERY. KEEP BATTERIES AWAY FROM CHILDREN. IF SWALLOWED OR PLACED INSIDE THE BODY, BATTERIES CAN CAUSE SEVERE OR FATAL INJURIES IN 2 HOURS OR LESS, SEEK IMMEDIATE MEDICAL CARE IF SUSPECTED.

NOTICE

NOTICE (United States of America)
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. (4) Consult the dealer or an experienced radio/ TV technician for help. FCC Radio Frequency Exposure Statement The device has been evaluated to meet general RF exposure requirements. The device can be used in fixed/mobile exposure condition. The min separation distance is 20cm. Notice: Shielded cables All connections to other computing devices must be made using shielded cables to maintain compliance with FCC regulations. The following importer is the responsible party Company Name: POWER MOBILE LIFE, LLC Address: 10900 NE 8th St, Ste 501, Bellevue WA 98004 Telephone:1-800-988-7973

NOTICE (Canada)
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

This Class B digital apparatus complies with Canadian ICES-003.

IC RF Statement: When using the product, maintain a distance of 20cm from the body to ensure compliance with RF exposure requirements.
♻ Your product is designed and manufactured with high quality materials and components, which can be recycled and reused.
This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps protect natural resources, human health and the environment. For more information on disposal and recycling of this product, contact your local municipality, disposal service, or the shop where you bought this product.
Anker Innovations Limited Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong

12-month limited warranty

United States +1 (800) 988 7973 Mon-Sat 6:15AM-6:45PM(PT) Sun 6:15AM-5:45PM(PT) United Kingdom +44 (0) 1604 936 200 Mon-Sun 6:00-19:00
Germany +49 (0) 69 9579 7960 Mo-Fr 8:00-16:00 Sa 9:00-16:00
support@eufylife.com

Anker Innovations Limited Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals