COSTWAY HW64404 3 Pcs Wicker Set User Manual
- June 4, 2024
- COSTWAY
Table of Contents
3 Pcs Wicker Set
HW64404
USER’S MANUAL
THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP IT FOR FUTURE REFERENCE
Before You Start
| Read
each step carefully before starting. It is very important to ensure each step
is followed in the correct order, otherwise, assembly difficulties may occur.
---|---
Most of the board parts are labeled or stamped on the raw edges. Have a check
to make sure all parts are included.
Work in a spacious area, preferably on a carpet close to where the unit will
be used.
Keep the hand tools close at hand. Do not use power tools to assemble your
furniture. They may scratch or damage the parts.
Board Identification
Not actual size
Left Arm x
2
|
Right Arm x
2
---|---
Seat and
Back Combination x 2
|
Cross Bar x 2
Hardware List
Actual size
STEP 1
Insert adjustable levelers (」) to the bottom of each Arm (A) by turning
clockwise until secure.
Adjust height as desired.
Repeat step for the other side arm(B).
STEP 2
Attach the Seat and Back Combination(C)to the arm (A&B) by inserting bolts (G)
with washers (H).
IMPORTANT: Do not tighten completely until assembly is completed.
STEP 3
Attach the crossbar(D) to the arm (A&B)by bolts (E) with washers (H). Attach
the crossbar(D) to the Seat and back combination(C)by bolts(F) with washers
(H).
STEP
4
Tighten all the bolts with the wrench, and turn the chair to the upright
position.
Your chair is now ready for use.
Maximum Loads
This item is only suitable within the specified maximum load-bearing. Heavier loads than the indicated load capacity may cause instability, resulting in possible injuries.
Board Identification
Not actual size
Table Top x 1
|
Table Leg x 3
---|---
|
---|---
STEP 1
Insert adjustable levelers (J) to the bottom of each Leg (L) by turning
clockwise until secure.
Adjust height as desired.
STEP
2
Join the table legs together, The adjustable levelers are put on the same
side.
STEP 3
Attach the glass(K)to the table leg (L) by inserting bolts {M) with washers
(H).
STEP4
Tighten all the bolts with the Allen wrench, and turn the table to the upright
position.
Your table is now ready for use.
Maximum Loads
WARNING
This item is only suitable within the specified maximum load-bearing. Heavier
loads than the indicated load capacity may cause instability, resulting in
possible injuries.
Care and Maintenance
Use a soft, clean cloth that will not scratch the surface when dusting.
The use of furniture polish is not necessary. Should you choose to use polish,
test first in an inconspicuous area. Using solvents of any kind on your
furniture may damage the finish. Never use water to clean your furniture as it
may cause damage to the finish.
Liquid spills should be removed immediately. Using a soft clean cloth, blot
the spill gently. Avoid rubbing. Check bolts/screws periodically and tighten
them if necessary.
Further advice about wood furniture care
Please protect your outdoor furniture with a cover when not in use since Long-
term sunlight exposure will result in damage on the surface.
In addition to sunlight damage, wood and metal frame suffers when exposed to
extremes in temperature and humidity.
Proper care and cleaning at home will extend the life of your purchase.
Following these important and helpful tips will enhance your furniture as it
ages.
Contact Us!
Do NOT return this item.
Contact our friendly customer service department for help first.