SENA Spyder 1R Mesh Intercom Headset Device User Manual
- June 9, 2024
- Sena
Table of Contents
Spyder 1R Mesh Intercom Headset Device
User Manual
Spyder 1R Mesh Intercom Headset Device
Charging
Red LED: Charging
Blue LED: Fully charged
Power On/Off
Press and hold the (+) Button and Center Button for 1 second
Tap the (+) Button and Center Button.
Volume Adjustment
(+) Button – Increase the volume
(-) Button – Decrease the volume
Battery Check
Phone, Music Pairing
Initially Pairing the Spyder 1R
The headset will automatically enter the phone pairing mode when you initially
turn on the headset or in the following situation:
• Rebooting after executing Factory Reset
- Press and hold the Center Button and (+) Button for 1 second.
- Search for Bluetooth devices on your mobile phone. Select the Spyder 1R in the list of the devices detected on the mobile phone.
- Enter 0000 for the PIN. Some mobile phones may not ask for the PIN.
Music Operation
Play or pause music: Press the Center Button for 1 second.
Track back: Press the (-) Button for 1 second.
Track forward: Press the (+) Button for 1 second.
Mobile Phone Call Making and Answering
- Answering a call: Tap the Center Button
- Ending a call: Press the Center Button for 2 seconds.
- Voice dial: Press the Center Button for 3 seconds.
- Speed dial: Press the (+) Button for 3 seconds.
- Rejecting a call: Press the (+) Button for 2 seconds.
Mesh Intercom
Mesh Intercom On/Off : Tap the Mesh Button
Setting
Configuration Menu: Press the Center Button for 10 seconds.
Troubleshooting
Factory Reset
If you want to restore the headset to factory default settings, use the
Factory Reset in the configuration menu. The headset automatically restores
the default settings and turns off.
Certification and Safety Approvals FCC Compliance Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device pursuant to part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment on and
off, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antennae
- Increase the separation between the equipment and the receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC RF Exposure Statement
This equipment complies with FCC/IC radiation exposure limits set forth for an
uncontrolled environment.
End users must follow the specific operating instructions for satisfying RF
exposure compliance.
When equipped, the distance between antenna and one’s head surface is 36mm.
FCC Caution
Any changes or modifications to the equipment not expressly approved by the
party responsible for compliance could void user’s authority to operate the
equipment.
Industry Canada(IC) Statement
This device complies with Industry Canada license-exempt RSS standard(s).
Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>