POTTER SB-24 Switchboard Instruction Manual
- June 9, 2024
- POTTER
Table of Contents
INSTALLATION MANUAL
SB-24 SWITCHBOARD
SB-24 Switchboard
NOTICE TO THE INSTALLER
This manual provides an overview and the installation instructions for the
SB-24 module. All terminals are power limited and should be wired in
accordance with the requirements of NFPA 70 (NEC) and NFPA 72 (National Fire
Alarm Code).
Failure to follow the wiring diagrams in the following pages will cause the
system to not operate as intended. For further information, refer to the
control panel installation instructions. The module shall only be installed
with listed control panels.
Refer to the control panel installation manual for proper system operation.
DESCRIPTION
The SB-24 switch board provides 24 programmable push buttons for zone
assignment. Each button has two corresponding LEDs to indicate activity and
trouble conditions. The SB-24 is equipped with a bracket for secure mounting.
A maximum of 4 SB-24’s can be installed within an IPA-4000V.
TECHNICAL SPECIFICATIONS
| Standby Current | 4 mA |
|---|---|
| Alarm Current | 27 mA |
| Operating Temperature Range | 32° to 120° F (0° to 49°C) |
| Operating Humidity Range | 10% to 93% (non-condensing) |
INSTALLATION
The SB-24 connects to the SB-8 through a 10 pin ribbon cable. The connections
are power limited and supervised. The SB-24 is equipped with bracket to
securely mount to the IPA-4000V and LOC-1000 dead front.
FIguRE 1. SB-24 INSTALLATION
PAGE 2 OF 2
Potter Electric Signal Company, LLC
St. Louis, MO
5409208-REV A 3/21
Phone:800-325-3936
www.pottersignal.com
firealarmresources.com
Documents / Resources
|
POTTER SB-24
Switchboard
[pdf] Instruction Manual
SB-24 Switchboard, SB-24, Switchboard
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>