Mircom UIMA4 Interface For Configuring Fire Panels Instructions
- June 9, 2024
- Mircom
Table of Contents
Mircom UIMA4 Interface For Configuring Fire Panels
Description
The UIMA4 is an interface for configuring FleX-Net™, FA-300, FX-350, FX-2000,
FX-3500, FX-3318, QX-5000, UDACT-300, MR-2300, MR-2350 and MMX panels.
The UIMA4’s ribbon cable can be disconnected and replaced
Interface
The UIMA4 interface has 3 connectors.
- 9 pin male serial connector for connecting the UIMA4 to the 9 pin male to female serial cable and then to the RS-232 serial port on some products
- USB B female connector for connecting the UIMA4 to the USB A to B male cable and then to the computer
- 10 pin female connector for connecting the UIMA4 to the configuration port or debug interface on some products
Features
- For configuring the following panels:
- FleX-Net™
- FA-300
- FX-350
- FX-2000
- FX-3500
- FX-3318
- QX-5000
- UDACT-300
- MR-2300
- MR-2350
- MMX
- For use with the FleX-Net™ MP Upgrade Wizard
- Includes one replacement 10 pin cable
Replacement Ribbon Cable
Ordering Information
| Model | Description |
|---|---|
| UIMA4 | Interface for Configuring MGC Fire Panels |
| RPL-WC-25022 | Replacement Ribbon Cable for UIMA4 (Pack of 3) |
| MGC-CONFIG-KIT4 | Fire Panel Configuration KIT1 with UIMA4 |
Canada
25 Interchange Way Vaughan, ON L4K 5W3 Telephone:
905-660-4655 | Fax:
905-660-4113
U.S.A.
4575 Witmer Industrial Estates Niagara Falls, NY 14305 Toll Free:
888-660-4655 | Fax Toll Free:
888-660-4113
www.mircom.com
THIS INFORMATION IS FOR MARKETING PURPOSES ONLY AND NOT INTENDED TO
DESCRIBE THE PRODUCTS TECHNICALLY.
For complete and accurate technical information relating to performance,
installation, testing and certification, refer to technical literature. This
document contains intellectual property of Mircom. The information is subject
to change by Mircom without notice. Mircom does not represent or warrant
correctness or completeness.