BLACK COUNTRY CUSTOMS Blackheath Bass Distortion Pedal User Manual
- June 9, 2024
- BLACK COUNTRY CUSTOMS
Table of Contents
Blackheath Bass Distortion Pedal
User Manual
INTRODUCTION
The Black Country Customs range of BASS pedals are born out of the desire to
achieve the best BASS tone possible.
The result of hours of dedicated testing and listening, each Black Country
Customs pedal is built using the highest quality components and engineered to
last a lifetime on your board.
WHAT IS THE “BLACKHEATH”
The BLACKHEATH is a bass distortion pedal dedicated to giving the bass player
all the tonal distortion they are looking for in a single pedal.
Featuring 2 different modes of Distortion and an Overdrive the BLACKHEATH
delivers all the classic distortion sounds you are looking for from aggressive
distortion, through tube like distortion and subtle distortions great for
adding character to clean sounds.
FEATURES
Each of the BCC pedals have been designed to incorporate features that really matter :-
- Transparent fully buffered operation at all times.
- Super high output drive provides an excellent interface between bass guitar and effects pedals/amp.
- Much reduced cable loss.
- Consistent bass guitar volume performance at all settings.
- Signal phase integrity.
- Excellent consistent load for passive Volume pedals.
- Ultra-low noise circuitry.
- Tri-coloured LED showing mode of operation.
- Silent switching.
- Low battery consumption.
LAYOUT
The layout of your pedal has been ergonomically designed by players, for
players, to give you control over all the features you need, quickly and
effectively.
The following pages will give you an insight into how the controls on the
BLACKHEATH work and interact with each other.
FEATURES
CONTROLS
-
GAIN
Control for the amount of drive into the distortion stage. Higher settings for a more distorted signal, lower settings for a little bit of grit. -
RANGE
Control for the amount of low end distortion. Setting the control to minimum allow the most low end out of the pedal giving you a thunderous growl. A maximum setting removes some of the low end frequencies and gives you a tighter sound for a more punchy mid-forward tone. -
VOLUME
Controls the output signal level of the distortion pedal. -
MODE
Changes the distortion character/tone.
DIST 1: An aggressive distortion character more akin to classic distortion pedals.
DIST 2: An asymmetrical distortion which gives more of a natural tube distortion tone.
OVERDRIVE: A less gain filled overdrive for more subtle uses. Great for adding a little bit of life into a clean tone.
-
COLOUR
Controls the hig frequency content of the distorted signal. Set high fro a brighter distortion. Set low for a darker distortion -
SIGNAL INPUT
Bass/Guitar/Instrument input.
Optimised for bass guitar but can accept other instruments. -
FOOT SWITCH
Enables / Disables the pedal. -
OUTPUT
The main FX output. This is a low noise high quality buffered output.
OPERATION
Install a good quality 9V battery into the pedal by unscrewing the base of the
pedal and fitting the battery securely to the battery connector and then
replace the base of the pedal. Do not use excessive force to tighten up the 4
base plate screws as this could damage the screws.
When not in use it is always a good idea to remove the input jack from your
pedal to prevent any unwanted battery power loss.
Caution – when you do not intend to use the pedal for a long period of
time, it is always advisable to remove the battery to prevent current loss and
battery leakage.
Alternatively – and highly recommended is the use of an external good
quality DC 9V PSU.
SPECIFICATIONS
Model: The BLACKHEATH
FX Type: BASS DISTORTION
Input Impedance: 1MΩ
Output Impedance: 100Ω
Noise Level (20-20KHz Filter): <50μV
Frequency Repose Bypassed: 20-20KHz (+/- 0.5 dB)
Recommended Minimum Load Impedance: 10KΩ
Power Supply: Regulated 9V DC PSU (Not Included), centre negative, 2.1 x
10 mm connector type. Internal 9V PP3 battery included (alkaline recommended)
Current Consumption: <10 mA
Battery Life: 30 hours – this will vary on use and selected battery
Unit Dimensions : 58.5 x 74 x 121.55 mm, 2.3” x 2.9” x 4.8”
Net Weight : 0.38 Kg, 0.8 lbs
Carton dimensions : 78.5 x 114.5 a 158 mm, 3.1” x 4.5” x 6.2”
Gross Weight : 0.6 Kg, 1.3 lbs
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference
- This device must accept any interference received, that may cause undesired operation.
Warning: Changes or modification to the equipment not approved by Laney
can void the user’s authority to use the equipment.
Note: This equipment has been tested and found to comply with the limits
for Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try and correct the
interference by one or more of the following measures.
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
** This product conforms to the requirements of the following European
Regulations, Directives & Rules:
CE Mark (93/68/EEC), Low Voltage 2014/35/EU, EMC (2014/30/EU), Ro
(2011/65/EU), RED (2014/30/EU), ErP 2009/125/EU
In order to reduce environmental damage, at the end of its useful life, this
product must not be disposed of along with normal household waste to landfill
sites. It must be taken to an approved recycling centre according to the
recommendations of the WEEE (Waste Electrical and Electronic Equipment)
directive applicable in your country.
SIMPLIFIED EU DECLARATION OF CONFORMITY**
Hereby, Laney Electronics Ltd. declares that the radio equipment is in
compliance with Directives 2014/53/EU, 2011/65/EU,2009/125/EU
Full text of the EU declaration of conformity is available at the following
internet address:
support.laney.co.uk/approvals
NOTES
Documents / Resources
|
BLACK COUNTRY CUSTOMS Blackheath Bass Distortion
Pedal
[pdf] User Manual
Blackheath Bass Distortion Pedal, Blackheath, Bass Distortion Pedal,
Distortion Pedal, Pedal
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>