MSI CLUTCH GM31 Lightweight Wireless User Manual
- June 9, 2024
- MSI
Table of Contents
CLUTCH GM31 Lightweight Wireless
User Manual
CLUTCH GM31 Lightweight Wireless
Overview
- Left Button
- Right Button
- Scroll Wheel
- Side Button 1 (Default Setting: Next Page)
- Side Button 2 (Default Setting: Previous Page)
- Diamond Pattern Anti-Slip Grip
- Dragon RGB LED Light
- Portable FriXionFree Cable
- DPI Switch
- Switch On/Off
- Optical Sensor
- Charging Port
- PTFE Skates
- Dongle (Used when CLUTCH GM31 LIGHTWEIGHT WIRELESS is active)
- Pogo Pin (Used when CLUTCH GM31 LIGHTWEIGHT WIRELESS is recharging)
- Dongle Port (Used when MSI Dongle is inserted)
- USB Type-C Connector
- Charger Anti-Slip Strip
LED Indicators Adjustment
Use the following buttons in combination repeatedly until the preferred
selection is made.
- DPI Switch + Right Button = adjust the LED brightness levels
- DPI Switch + Scroll Wheel = select a LED Lighting Effect
- DPI Switch + Side Button 1 = adjust the Lighting Effect Speed
- DPI Switch + Side Button 2 = select a LED Color
- For more information, please visit MSI official website.
5-level DPI Presets
The higher DPI will be recommended to the monitors with higher resolution.
Press repeatedly the DPI switch located underneath the mouse until the
preferred selection is made.
| LED color | DPI |
|---|---|
| Blue | 400 |
| Purple | 800 |
| Red | 1600（default） |
| Yellow | 3200 |
| Green | 6400 |
※ Maximum DPI: 12000（by software）
Battery Capacity Indicator
Read the color of the Dragon RGB LED indicator to learn the battery capacity
of the mouse.
| Battery capacity | LED color |
|---|---|
| 90% – 100% | Steady Green |
| 70% – 90% | Breathing Green |
| 50% – 70% | Breathing Yellow |
| 30% – 50% | Breathing Orange |
| 10% – 30% | Breathing Red |
| 0% – 10% | Flashing Red |
※ Battery Percentage (%) can also be found in Dragon Center / MSI Center
※ Rated Voltage / Current : 5V == 250mA；Maximum Operating Temperature : 40 °C
※ For more information, please visit MSI official website
FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any changes or modification not expressly approved by the party responsible
for compliance could void the user’s authority to operate the device. Where
shielded interface cables have been provided with the product or specified
additional components or accessories elsewhere defined to be used with the
installation of the product, they must be used in order to ensure compliance
with FCC regulations.
Hereby, MSI declares that the radio equipment type GM31W is in compliance with
Directive 2014/53/EU. The full text of the EU declaration of conformity is
available at the following internet address: www.msi.com
| Mouse| Dongle
---|---|---
FCC| 14L-GM31W| 14L-GM31WD
NCC| CCAH22LP3420T8| CCAH22LP3430T1
IC| 3715A-GM31W| 3715A-GM31WD
Specifications
Mouse Input/: DC 5.0V/250mA
Dongle Input/: DC 5.0V/30mA
Mouse/ Dongle Frequency range :
2.400-2.4835GHz
Mouse Output power :8.63dBm
Dongle output power :6.69dBm
ISED Compliance Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-exempt
RSS(s). Operation is subject to the following two conditions: (1)This device
may not cause interference.(2)This device must accept any interference,
including interference that may cause undesired operation of the device.
RF Exposure Statement
This equipment complies with FCC/IC RSS‐102 radiation exposure limits set
forth for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20cm between the radiator and your body.
Micro-Star INT’L CO., LTD.
No.69, Lide St., Zhonghe Dist., New Taipei City 235, Taiwan
tel: +886-2-3234-5599 fax:+886-2-3234-5488 www.msi.com
MSI-Europe Eindhoven 5706 5692 ER Son
Documents / Resources
| MSI
CLUTCH GM31 Lightweight
Wireless
[pdf] User Manual
CLUTCH GM31 Lightweight Wireless, CLUTCH GM31, Lightweight Wireless, Wireless
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>